Assessments - 2, GPA: 5
(
)
)
|
Facilidade de uso
v Insert the key into the socket. Circuit breaker has been triggered (Red Error-LED flashes). v Wait approx. 5-10 minutes then turn on the mower again. Tab on Accu loose. v Open the cover and push the tab receptacle onto the tab. Full discharge protection has responded. v Charge Accu. Motor jams and is noisy Blocked by foreign body. Blocking protection activated. (Red Error-LED flashes). 1. Switch off mower, 2. Remove key. 3. Remove foreign body. Cutting load too high. v Reduce mowing speed and / or raise cutting height. Motor turns off The cutting height you have selected is too low; Circuit breaker has been activated. (Red Error-LED flashes). Let the motor cool for 5-10 minutes, then use the mower with a higher cutting height and reduce the cutting height in stages until you reach the lower cutting height you require. Runs unevenly, mower vibrates significantly Cutting tool damaged. v Have cutting tool checked by an authorised specialist dealer or GARDENA- Service. Blade very dirty. v Clean blade. Lawn cut unevenly Blade set incorrectly. v Adjust cutting mechanism. Cutting mechanism blunt. Recommendation: v Have cutting mechanism reground or replaced by GARDENA Service. Lawn too long. v See 4. Function “Mowing Tips”. Readjusting the cutting mechanism: The cutting gear of your lawn mower was optimally adjusted before leaving our company. If, after longer use, a clean cut of the grass is no longer possible or the blade roller contacts the lower blade, then the lower blade should be adjusted as follows: 18 ORPQ OSP Changing Accu: EFCD Repairs: 1. Unhook upright and clean cylinder mower. 2. Check cylinder O and lower blade P for notches and remove these with a grindstone if necessary. 3. Unscrew internal hexagon screws Q with an internal hexagon wrench (5 mm) anticlockwise until the cylinder O turns freely. 4. Push the feeler gauge supplied (thin strip of metal) R between one blade O on the cylinder and the lower blade P. 5. Tighten left internal hexagon screw Q with an internal hexagon wrench (5 mm) until the feeler gauge R is held gently. 6. Continue turning the cylinder until the blade O, already adjusted on the left side, is exactly above the lower blade P on the right side. 7. Tighten the right internal hexagon screw Q with an internal hexagon wrench (5 mm) until the feeler gauge R is held gently. 8. Rotate cylinder O. If a banging noise is produced during this, open up the internal hexagon screw Q slightly on the side affected. When the cylinder and the lower blade can hardly be heard touching each other, the cutting mechanism has been adjusted correctly. 9. Cutting test: Place a strip of paper S in such a way on the lower blade P that it points towards the spindle of the cylinder O. 10. Turn cylinder O carefully. If the lower blade is set correctly P the paper will be cut off as if with scissors. 11. Repeat the cutting test on the other blades O. If the Accu capacity is completely exhausted or if the Accu can no longer be recharged it must b...
Este manual também é adequado para os modelos :Cortadores de grama - ART 4026 380 AC (196.65 kb)
Cortadores de grama - ART 4026 380 AC (196.65 kb)
Cortadores de grama - ART 4026 380 AC (196.65 kb)
Cortadores de grama - ART 4026 380 AC (196.65 kb)