Assessments - 3, GPA: 4
(
)
)
|
Facilidade de uso
Self-discharging is reduced at low storage temperatures. If the Accu is completely flat, e.g. due to too long storage without any recharge, it will get its full efficiency again after several charging cycles. The product must not be added to normal household waste. It must be disposed of in line with local environmental regulations. GB Disposing of The Accu contains lead cells. After their lifetime have expired, they the Accu: may not be disposed of as normal house rubbish, but must be disposed of properly. Please dispose of the flat Accu via the municipal disposal point. 7. Maintenance Pb Cleaning the mower: Charge Accu: GH NM A A DANGER! Cutting tool can cause injuries! V When undertaking maintenance, remove the safety key, wait for the cutting mechanism to stop and put on suitable work gloves. A A Warning! Damage to Accu cylinder mower. V Never clean your cylinder mower with running water, in particular with water under high pressure. Deposits affect the cutting result as well as discharge of grass clippings. Residual dirt and grass is easily removed immediately after mowing. 1. Remove grass deposits with a brush and a cloth. 2. Oil the red cutting mechanism lightly with low viscosity oil (e.g. sprayed oil). We recommed charging the Accu with the charger supplied, immediately after mowing with the cylinder mower and leaving it connected to the charger (the Accu cannot be over-charged). Do not wait to charge until the Accu is completely flat. 1. Remove safety key G from the charging socket H. 2. Insert mains plug of the charger M in a mains socket. The red LED goes on. 3. Insert charging plug N of the charger into the charging socket H. 4. When the green LED of the charger goes on, the Accu is fully charged. (This can take up to 24 hours if the Accu is flat). When the charger M is disconnected from the mains, the charging plug N must also be removed from the charging socket H as otherwise the Accu will discharge itself via the charger. 17 GB 8. Troubleshooting / Service DANGER! Cutting tool can cause injuries! V When rectifying faults remove the key and wear suitable work gloves. Problem Possible cause Remedy Abnormal noise. Clattering in the mower Screws / components loose. v Tighten screws or send to GARDENA Service. Foreign bodies on the blade. v Remove foreign bodies. Notch in the blade. v Remove notches with grindstone. Blades are striking each other too hard. v Adjust cutting mechanism. Motor will not start Key not inserted. v Insert the key into the socket. Circuit breaker has been triggered (Red Error-LED flashes). v Wait approx. 5-10 minutes then turn on the mower again. Tab on Accu loose. v Open the cover and push the tab receptacle onto the tab. Full discharge protection has responded. v Charge Accu. Motor jams and is noisy Blocked by foreign body. Blocking protection activated. (Red Error-LED flashes). 1. Switch off mower, 2. Remove key. 3. Remove foreign body. Cutting load too high. v Reduce mowing speed and / or raise cutting heig...
Este manual também é adequado para os modelos :Cortadores de grama - ART 4026 380 AC (196.65 kb)
Cortadores de grama - ART 4026 380 AC (196.65 kb)
Cortadores de grama - ART 4026 380 AC (196.65 kb)
Cortadores de grama - ART 4026 380 AC (196.65 kb)