Assessments - 2, GPA: 3.5 ( )

Fabricante : Agri-Fab Arquivo Tamanho: 2.32 mb Arquivo Nome : Língua de Ensino:

Be aware of changing conditions on slopes. 1. Inspect the Mow-N-Vac to make sure all covers (rear door, vinyl boot, elbow, hose adapter (nozzle), hose and deck adapter are properly attached. 2. Check tires for proper inflation (12 - 14 lbs). 3. Check oil and gas in Mow-N-Vac engine. 4. Begin operation at low speed, adjusting forward speed to match grass height and/or moisture condition to prevent clogging. 5. Do not attempt to vacuum up any material other than vegetation found in a normal yard, such as light branches, leaves, twigs, etc. 6. To empty cart, shut off tractor engine and set brake. 7. Shut off Mow-N-Vac engine. 8. Remove rear door from cart. 9. Release the latch holding cart down to the tongue by pulling up on the latch lever. See figure 28. 10. Using a rake or suitable tool, pull the grass clippings and/or leaves out of cart. 11. After cart is emptied, secure cart to tongue with latch and reattach the rear door and vinyl boot. WARNING: Never fill fuel tank indoors, or with the engine running, or while the engine is hot. Do not smoke while filling tank. HOW TO STOP YOUR MOW-N-VAC 1. To stop engine, move the throttle control lever to the OFF position. 2. Disconnect spark plug wire from plug to prevent accidental starting while equipment is unattended or is being worked on. WARNING: Should your Mow-N-Vac become clogged, shut off tractor and Mow-N-Vac engines. Before attempting to unclog, remove wire from spark plug to prevent accidental starting. CAUTION: The muffler and adjacent areas are hot! HOW TO START YOUR MOW-N-VAC CAUTION: To avoid possible injury, be sure that no one is near the cart before releasing the latch. WARNING: Never start or run the engine without all covers being properly attached to the blower housing and cart. 1. Check oil and gas in Mow-N-Vac engine. 2. Attach spark plug wire to spark plug. 3. Move choke lever on engine to CHOKE position. (A warm engine may not require choking.) 4. Move throttle control lever on engine to FAST position. 5. Grasp starter handle and pull rope out slowly until engine reaches start of compression cycle (rope will pull slightly harder at this point). Let the rope rewind slowly. 6. Pull rope with a rapid, continuous, full arm stroke. Keep a firm grip on starter handle. Let rope rewind slowly. Do not let starter handle snap back against starter. 7. Repeat instructions in two preceding paragraphs until engine fires. When engine starts, move choke control gradually to RUN position. FIGURE 28 MAINTENANCE CUSTOMER RESPONSIBILITIES • Read and follow the maintenance schedule and the maintenance procedures listed in this section. Every season Before storage Before each use After each use MAINTENANCE SCHEDULE Fill in dates as you complete regular service. Service Dates Check for loose fasteners X Check soft vinyl boot X Check tire pressure X Check engine oil level X Lubricate X Clean X X Maintain engine per instructions below and in engine manual. BEFORE EACH USE CHECK FOR LOOSE FASTENERS 1. Make a thorough visual check of the Mow-N- Vac for any bolts and nuts which may have loosened. Retighten any loose bolts and nuts. CHECK VINYL BOOT 2. Check the soft vinyl boot (on front of hard top) for wear. Replace if worn or damaged. CHECK TIRE PRESSURE 3. Check tire pressure regularly. Recommended tire pressure is 12-14 Lbs. CHECK ENGINE OIL LEVEL 4. Check oil level before each use. Maintain engine oil as instructed in the separate engine manual. WARNING: Always stop engine and disconnect spark plug wire before cleaning, lubricating or before performing any repairs or maintenance. ENGINE MAINTENANCE 1. Check oil level before each use. Maintain engine oil as instructed in the separate engine manual. 2. Service air cleaner every 25 hours under normal conditions. Clean every few hours under extremely dusty conditions. Poor engine performance and flooding usually indicates that the air cleaner should be serviced. To service the air cleaner, refer to the separate engine manual. 3. The spark plug should be cleaned and the gap reset once a season. Spark plug replacement is recommended at the start of each season. Check the engine manual for correct plug type and gap specifications. LUBRICATION 1. At the beginning of each season, lubricate the latch, latch pivot bolt, and the axle where the hitch tongue pivots, with a light machine oil. 2. At least once a season, grease or oil the wheel bearings. Use automotive wheel bearing type grease or 20 weight oil. CLEANING 1. Make sure the cart, the side and front panels and top are cleaned after each use. Grass clippings and leaves left in the cart will mildew and cause damage if not cleaned out. 2. Clean the engine regularly with a cloth or brush. Keep the cooling fins on the engine housing clean to permit proper air circulation which is essential to engine performance and life. Be sure to remove all dirt and debris from muffler area. STORAGE 1. Clean the engine and the entire unit thoroughly. 2. Refer to engine manual for correc...

Baixe o seu

Para fazer o download, introduza 2 dígitos :