Assessments - 2, GPA: 4.5
(
)
)
|
Facilidade de uso
WARRANTY COVERAGE MAY BE AFFECTED WITHOUT PROPER CLEANING. Cleaning Hints: 1. Use the mildest cleaning procedure that will do the job. 2. Always rub in the direction of polish lines to avoid scratching the surface. MAINTENANCE: CABINET 1. Wipe the inside of cabinet after daily use. 2. Leave doors slightly open to fully dry interior. BEFORE cleaning the cabinet: 1. Unplug cord from wall. Allow cabinet to cool. 2. Do NOT hose cabinet with water. 3. Do NOT get water on controls. 4. Do NOT use abrasives or harsh chemicals. 3. Use only a soft cloth, sponge, fibrous brushes, plastic or stainless steel pads for cleaning and scouring. 4. Rinse thoroughly with fresh water after every cleaning operation. 5. Always wipe dry to avoid water marks. SOIL CLEANER METHOD CABINET Inside and Outside (Stainless Steel) Routine Cleaning Soap, ammonia or mild detergent* and water. 1. Sponge on with cloth 2. Rinse Stubborn Spots, Stains Mild abrasive made for Stainless Steel. 1. Apply with damp sponge or cloth. 2. Rub lightly. Burnt on Foods or Grease Chemical oven cleaner made for Stainless Steel. Follow oven cleaner manufacturer’s directions. Hard Water Spots & Scale Vinegar 1. Swab or wipe with cloth. 2. Rinse and dry. *MILD DETERGENTS INCLUDE SOAPS AND NON-ABRASIVE CLEANERS. 5925 Heisley Road • Mentor, OH 44060-1833 877/CRES COR (273-7267) • 440/350-1100 Fax: 440/350-7267 • Ovens Humidity with Microprocessor Controls FL-2267 Rev. 8 (1/05) Page 8 of 13 MAINTENANCE INSTRUCTIONS TROUBLE-SHOOTING GUIDE If unit gets too hot or won’t shut off, disconnect power at branch panel. DO NOT UNPLUG CORD! If hot unit is NOT working, first check the following causes: 1. Cord is unplugged from wall outlet. 3. Switch is turned off. 2. Circuit breaker/fuse to wall outlet is blown. 4. Thermostat is turned off, or is set too low. PROBLEM POSSIBLE CAUSE SOLUTION Cabinet does not heat, or doesn’t heat properly 1. Fuse 2. Control 3. Sensor 4. Heater contactor 5. Loose wiring at heater contactor 6. On/Off Switch 1. Replace 2. Replace 3. Replace 4. Replace 5. Replace 6. Replace Blowers do not operate 1. On/Off Switch 2. Fuse 3. Blower 4. Control 1. Replace 2. Replace 3. Replace 4. Replace Heater will not shut off 1. Control defective 1. Replace Vent fans does not shut off 1. Vent fan switch defective 2. Control compartment is still hot. 1. Replace 2. Wait until it cools Check “Heaters will not shutoff” Vent fans does not operate 1. Fuse 2. Vent fan switch defective 3. Vent fan defective 1. Replace 2. Replace 3. Replace Control will not switch from “COOK” to “HOLD” (timer mode) 1. Oven is in “PROBE” mode. 2. Control defective 1. Switch to “TIMED” mode 2. Replace Control will not switch from “COOK” to “HOLD” (probe mode) 1. Oven is in the “TIMED” mode 2. Probe not plugged in 3. Control defective 1. Switch to “PROBE” mode 2. Plug in probe 3. Replace Control will not switch to “COOK” (probe mode) 1. Oven in “TIMED” mode 2. Probe temperature setting lower than probe temperature 3....
Este manual também é adequado para os modelos :Fornos Elétricos - CO151HWUA5B (980.21 kb)
Fornos Elétricos - CO151FPWUA12B (980.21 kb)
Fornos Elétricos - CO151HWUA6B (980.21 kb)
Fornos Elétricos - RO151FPWUA12B (980.21 kb)