Assessments - 4, GPA: 4.3
(
)
)
|
Facilidade de uso
-the Quick-on regulator handle is in the closed position. Then, dismount the Quick-on by pressing horizontally on the handle and pulling upwards at the same time (fig.5). 2 Do not attempt to carry out this operation with the regulator handle in the open position. Handle horizontally flame Off CLOSED GAS OFF fig.4 GAS OFF1 fig.5 3 GENERAL SAFETY INSTRUCTIONS Type Category Max.output Med.output Low output Gas Presure Gas combustion air quantity See Rating label Kw g/h 4.2 305 Kw g/h 2.85 207 Kw g/h 1.50 109 28-30 mbar 8.4 m3/h this appliance is designed to operate with butane, at nominal pressure: 28.30 mbar CYLINDER VALVE If heater does not competely extinguish, including pilot, when gas is turned off at the regulator, do not remove regulator. Return valve to open position and leave heater alight, which is perfectly safe, until attended to by the gas supplier. Regulators, Hoses and clips Check that tubing is completely over the nozzles at each end of the tubing and that is held firmly in place by tube clips. Examine flexible tubing regularly and get your Dealer to fit new tubing 400 mm long if perished, worn or damaged. L.P.G. ATTACKS NATURAL RUBBER-USE ONLY TUBING TO B.S. 3212 TYPE 2 SUPPLIED BY YOUR DEALER. Avoid bending or constricting the rubber tube when the pressure regulator is connected to the gas cylinder. AREGULATOR B.S. 3016 SET AT 28 MBAR (11.2 IN W.G.) for butane must de connected to the appliance with the above tubing, using suitable tube clips. VENTILATION USE ONLY IN A WELL VENTILATED ROOM Adequate ventilation must be provided in rooms in which the heater is use. This ensures removal of the products combustion and allows the entry of replacement air. Adequate ventilation should considerably reduce the possibility of condensation accurring. The following table shows the smallest size of room suitable for each heat setting and the ventilation which must be provided. Heating Setting Room Size Room Vent MIN 15 m3 105 cm2MAX 42 m3 MED 28,5 m3 MAINTENANCE Ensure that the heater is kept free of dust. When the heater is not in use it should be covered and stored in a dust-free place. Stains on the exterior should be removed with soapy solution when the heater is cold. Dry with a polishing cloth. DO NOT use abrasive cleaners which will damage the paint finishes. Refer any major maintenance to your Local Authorised Dealer. Major servicing should be carried out annually. If in doubt refer to your authorised dealer. SAFETY GUARD The guard on this appliance conforms to the requirements of B.S. 1945: 1971 and satisfies the heater appliance (fireguards) regulations. The guard is to prevent risk of fire or injury from burns and no part of it should be permanently removed. It does not give full protection for young children or the infirm. 4 Positioning the heater: • DO NOT place clothes or other materials on the heater. • DO NOT position heater close to chairs or fabrics • DO NOT MOVE the heater across the room when lit. • DO NOT POSITION the heater alongside a wall or near curtains etc. • ALWAYS face the heater towards the centre of the room. OPERATING INSTRUCTIONS Before connecting a gas container and operating this appliance, please read the heater safety instructions and the operating instructions given below - spare copies may be obtained from your authorised dealer. The gas is turned on and off at the cylinder. The heat input and spark for ignition are controlled by the knob situated at the top right hand side of the heater. LIGHTING THE HEATER: 1) Turn on the gas cylinder by either: Handle verically OPEN flame On Turn the regulator gas switch anti- clockwise to the vertical position Handle horizontally flame Off CLOSED 2. FROM . heat up, then turn the knob to the required heat setting. CONTROL OF THE HEAT OUTPUT: For low output - leave control knob in position (small flame) For full output - slightly depress knob and rotate to position For medium output - slightly depress knob and rotate to position TURNING-OFF THE HEATER each use the appliance must be turned “OFF” at the regulator valve. Turn the regulator gas switch clockwise to the position GAS OFF DO NOT ATTEMPT to relight until FIVE minutes have elapsed. WARNING FOR SWITCH-ON SYSTEM: When the heat is alight, NEVER turn the switch on the cylinder to the disconnect position. Wait until heat and pilot go out, then and only then, should the switch be turned to the disconnect position if the cylinder requires changing. It is dangerous to switch to the disconnect position when the heater is alight. 5 5721007200/ 07.03 ...
Este manual também é adequado para os modelos :Eléctrico - 634H (470.92 kb)