Assessments - 1, GPA: 5 ( )

Fabricante : Empire Comfort Systems Arquivo Tamanho: 4.64 mb Arquivo Nome : Língua de Ensino:

Gas supply piping should also be planned at this time. A gas shut off must be in this line. 45° 6” 3” MAX. PERPENDICULAR SIDE WALL FRONT FACE (SIDE) FIREBOX (TOP VIEW) COMBUSTIBLE MATERIALS ALLOWED IN SHADED AREAS FIREBOX STAND OFF FINISH WITH TRIM KIT OR NON-COMBUSTIBLE MATERIAL AS DESIRED. COMBUSTIBLE FINISHED WALL 2 X 4 OR MANTEL HEADER MANTEL HOOD 13” 10” 12” MAX 42” MIN. (CEILING TO TOP OF HOOD) 11 1/2” MIN. FIREBOX FACE 84” MIN. (CEILING TO FLOOR) CEILING COMBUSTIBLES ALLOWED 3/8” COMBUSTIBLE CLEARANCE REQUIRED FROM TOP EDGE OF FIREBOX 10” 22” 8” 20” 6 .” 18” 5” 16” 3 .” 14” 2” 12 .” 3/4” 24 .” 0” Figure 1 Figure 2 Figure 3 CLEARANCES FIREBOX INSTALLATION INSTRUCTIONS 23200-0-1206 Page 5 Deluxe Vent-Free Firebox Framing Dimensions (in inches) "A" "B" "C" Model Framing Height Framing Width Framing Depth VFD32FB 36 1/8" 35" 17" VFD36FB 38 1/8" 40" 19 3/8" VFD42FB 38 1/8" 44" 19 3/8" Attention: Add 3-3/4" to "A" Dimension when using flush mantel base. Framing dimension A includes a three inch clearance for standoffs on firebox. Accessory kits such as the FBB5 Blower kit, Trim kits, Mantles, Full Cabinet Mantels, plus other Decorative Frame, Hood, and Door accessory kits may be installed after the firebox is secured to the framed opening. Refer to the instructions provided with each of the optional accessory kits for proper installation and operation. Firebox Framing Firebox framing can be built before or after the firebox is set in place. Framing should be positioned to accommodate wall covering and firebox facing material. The firebox framing should be constructed of 2 x 4 lumber or heavier. The framing headers may rest on the top of the firebox standoffs. Refer to Figures 6 and 7 for firebox framing dimensions. The firebox can be mounted on any of these surfaces: 1. A flat hard combustible or non-combustible surface. 2. A raised platform of combustible or non-combustible material. 3. Recessed into the floor as illustrated by Figure 4 (flush face), and Figure 5 (louvered models). 4. Supported under all (4) corners of the firebox so that contact is made on all four perimeter edges on the bottom of the unit (Example: Four (4) concrete masonry blocks). If the firebox is installed directly on carpeting, tile or other combustible material other than wood flooring, it should be installed on a metal or wood panel extending the full width and depth of the unit. At this point, you should have decided what components to include in your installation, and where the firebox is to be located. If this has not been done, stop and consult your dealer for assistance with this planning. Planning Your Installation Please note that the optional BVA1 Fresh Air kit available for use with the Vent Free Firebox must be installed at the time of the initial installation. Refer to pages 9, 10, and 11 for detailed instructions for the air kit. COMBUSTIBLE MATERIALS ALLOWED NON-COMBUSTIBLE FINISHING MATERIAL TO FIREBOX OPENING FLUSH FACE MODELS LOUVERED FIREBOX MODELS COM...

Baixe o seu

Para fazer o download, introduza 2 dígitos :