Assessments - 3, GPA: 4
(
)
)
|
Facilidade de uso
. • Disconnect the battery holder wires from the red and black wires of the wiring harness from the switch and module. Connect the red and black wires of the wiring assembly included with the electric kit to the red and black wires to the switch and module. Plug the power supply wire into the wire assembly and then into the outlet. See Figure 6.12. • If installing optional remote control, disconnect the brown module wire from the red jumper wire. See Figure 6.12. Follow the instructions included with the remote control. • Replace the cover on the control box. Figure 6.10 Assemble Junction Box Figure 6.11 Replace Control Cover Outdoor Lifestyles by Hearth & Home Technologies Inc. • Carolina • 4066-300 • Rev. V • 4/12 Outdoor Lifestyles by Hearth & Home Technologies Inc. • Carolina • 4066-300 • Rev. V • 4/12 17 Figure 6.12 Intermittent Pilot Ignition (IPI) Wiring Diagram with Optional Electric Kit and Optional Remote Control RC100 (optional) External Control Switch Valve Module Pilot assembly Wiring harness Red Jumper wire Battery holder RED RED BRN BLK BLK GRN ORG ORG WHT Optional Electric Kit Outlet box cover Outdoor GFI Outlet Power supply Fuse RC200 (optional) If a remote is used, the brown module wire must be disconnected from the red jumper wire. BLK RED * Optional Remote Control * Battery holder MUST be removed to install the optional electric kit. 7 77 Finishing A. Mantel Projections WARNING! Risk of Fire! Comply with all minimum clearances to combustibles as specified. Framing or finishing Figure 7.1 shows the dimensions for mantels or other com material closer than the minimums listed must be construct bustible projections above the fireplace opening. ed entirely of noncombustible materials (i.e., steel studs, concrete board, etc.). Fireplace StructureNoncombustible mat’lMantel 25 in. (635 mm) minimum Ceiling or Overhang 12 in. (305 mm) max. combustible mantel depth Figure 7.1 Clearances to Mantels or other Combustibles above Appliance. B. Facing Material The appliance can be covered with any noncombustible material. Refer to Section 1.D. It is possible for the face of the unit above the fireplace opening to show signs of soot. Clean that area as frequently as necessary to eliminate a build up of soot or permanent discoloration. A noncombustible ledge (shelf) approximately 3 inches above the opening and a minimum of 3 inches out from the face of the unit incorporated into the facing material will help prevent the soot from going up the wall. Note: The control box lid can be painted as desired. Use sandpaper or other abrasive material to scuff the surface prior to painting. Outdoor Lifestyles by Hearth & Home Technologies Inc. • Carolina • 4066-300 • Rev. V • 4/12 8 88 Appliance Setup A. Clean the Appliance Clean/vacuum any material that may have accumulated inside the firebox. B. Optional Accessories Install approved accessories per instructions included with accessories. Contact your dealer for a list of approved accessories. WARNING! Risk of Fire and Electric Shock! Use ONLY Hearth & Home Technologies-approved optional accessories with this appliance. Using non-listed accessories could result in a safety hazard and will void the warranty. Figure 8.2 Install Lava Rock C. Pilot Shield Ensure the pilot shield is still in the position shown in the photo below. Shipping could cause it to become displaced. E. Positioning the Logs CAROLINA-36 • Place the rear log on the shelf against the appliance rear Figure 8.1 Pilot Shield Position wall. Position log as far back on the shelf as possible. D. Install Lava Rock Pour lava rock into the burner pan and cover the burner tube. DO NOT cover the burner tube from the right grate support to the pilot assembly. See Figure 8.2 & 8.3. There is extra rock provided to cover the front of the firebox if desired. NOTICE! Do not cover area around pilot assembly with lava rock. Too much rock will interfere with pilot flame ignition, rectification, and wind stability. PILOT SHIELD HEAT SHIELD PILOT BRACKET Figure 8.3 Install Lava Rock NO LAVAROCK IN THIS AREANO LAVA ROCK IN THIS AREA PUSH LOG TO BACK OF SHELF Figure 8.4 Place Rear Log - Carolina-36 Outdoor Lifestyles by Hearth & Home Technologies Inc. • Carolina • 4066-300 • Rev. V • 4/12 • Place the left front log on the grate against the front of the • Place the top left log into the indentations on the rear and grate. Fit notch in log to grate bar as shown below. left front logs. Notch against grate Figure 8.5 Place Left Front Log - 36 Figure 8.8 Place Top Left Log - 36 • Place the fork of the center Y log above the middle front grate bar and rest its back on the indentation in the middle of the rear log. Figure 8.6 Place Right Front Log • Place right front log on the grate against the front of the grate. Fit notches into the bottom of the log to position it as shown in Figure 8.6 • Place the top center log as shown below. • Place the top right log. There are flat indentations on the rear and right front logs to locate t...
Este manual também é adequado para os modelos :Lareiras - CARDOG36IL (2.82 mb)
Lareiras - CARODG36I (2.82 mb)
Lareiras - CARDOG42IL (2.82 mb)