Assessments - 6, GPA: 4.2
(
)
)
|
Facilidade de uso
27. Never attach duct work to front or rear of heater. 28. Use only original replacement parts. This heater must use design-specific parts. Do not substitute or use generic parts. Improper replacement parts could cause serious or fatal injuries. 29. Do not use this product without leg and foot assembly. Product Identification Safety Information Continued Hot Air Outlet (Front) Burn Rate Adjustment Knob Handle Automatic Gas Control Valve Button Air Inlet (Rear) Cord Cleat Adjustable Foot Figure 1 - 55/85/125,000 Btu/Hr Models Hot Air Outlet (Front) Thermostat Knob Handle Burn Rate Adjustment Knob Adjustable Foot Air Inlet (Rear) Cord Cleat Figure 2 - 170,000 Btu/Hr Models Unpacking 1. Remove all packing items applied to heater for shipment. Keep plastic cover cap (attached to heater inlet connector and hose/regulator assembly) for storage. 2. Remove all items from carton. 3. Check all items for shipping damage. If heater is damaged, promptly inform dealer where you bought heater. Assembly IMPORTANT: Do not use this product without leg and foot assembly. Handle Attach handle to control box with 2 screws (long) as shown in Figure 3. Plastic Foot and Leg Extensions 1. Insert leg extensions into outlet end cap until small hole lines up with larger hole, visible from inside of outlet end cap (see Figure 3). Fasten leg extensions with provided screws (short). 2. Insert plastic foot ends into each leg extension and set heater to desired angle. Small post screws on plastic foot will snap into holes in leg extensions. Cord Cleats Install cord cleats on side of end caps as shown in Figure 3 with screws provided (short). Theory of Operation The Fuel System: The hose/regulator assembly attaches to the propane gas supply. For 55/85/125 models, the propane gas moves through the automatic control valve, burn rate adjustment valve and out the injector. For 170 models, the propane gas moves through the solenoid valve, burn rate adjustment valve and out the injector. The Air System: The motor turns the fan. The fan pushes air into and around the combustion chamber. This air is heated and provides a stream of clean, hot air. The Ignition System: For 55/85/125 models the high voltage ignitor sends voltage to the spark ignitor. For 170 models direct spark ignitor sends voltage to the spark ignitor. The spark ignitor ignites the fuel and air mixture. The Safety Control System: This system causes the heater to shut down if the flame goes out. The motor will continue to run, but no heat is produced. Long screws Outlet End Cap Handle Cord Cleat Short Screw Leg Extension Fastening Screw (short) Small Post Leg Extension Plastic Foot Figure 3 - Handle and Foot Assembly Automatic Control Valve (55/85/125 models only) High Voltage Ignitor (55/85/125 Models) or DSI (170 Models) Solenoid Valve (170 models only) Air ForCombustion Air ForHeating Injector Thermal Limit Switch Hose/ Regulator Assembly Power Cord Clean Heated Air Out (Front) Cool Air In (Back) Spark Ignitor Motor Com...
Este manual também é adequado para os modelos :Aparelhos de ar condicionado - 000 BTU TB101 (3.52 mb)
Aparelhos de ar condicionado - TB100 (3.52 mb)
Aparelhos de ar condicionado - TB104 (3.52 mb)
Aparelhos de ar condicionado - TB105 (3.52 mb)