Assessments - 4, GPA: 4.3 ( )

Fabricante : Briggs & Stratton Arquivo Tamanho: 458.36 kb Arquivo Nome : Língua de Ensino:

You should never run this pressure washer for more than 2 minutes without pulling the trigger to allow cool water to enter the pump and the heated (recirculated) water to exit. ASSEMBLY 1. Place handle assembly onto frame and connect handle to frame. 2. Connect wand to gun. Tighten securely. 3. Attach high pressure hose to gun. Tighten securely. 5. Assemble grommet kit and quick-connect nozzles as described in instructions supplied. 6. Add engine oil (supplied) to engine. Refer to engine manual supplied by engine manufacturer for correct procedure. NOTE: There will be a slight amount of oil in the engine from factory testing. NOTE: The high pressure pump was filled with oil at the factory. There is no need to add oil at this time, see the Maintenance section of this manual for Maintenance information. 7- ENG D25806 OPERATION Know Your Pressure Washer READ THIS OWNER’S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR UNIT. Compare the illustrations with your unit to familiarize yourself with the location of various controls and adjustments. Save this manual for future reference. Quick Quick Connect Connect Nozzles Gear Reduced High Pressure Pump Engine High Pressure Hose Spray Gun Wand PRESSURE WASHER Gear Reduced High Pressure Pump: Increases the pressure of the water supply. Engine: Drives the high pressure pump. High Pressure Hose: Carries the pressurized water from the pump to the gun and wand. Spray Gun: Connects with wand to control water flow rate, direction, and pressure. Quick Connect Wand: Wand is equipped with a female quick connect coupler on the end. This allows the user to quickly change out high-pressure nozzles for different spray patterns and change to the soap nozzle for low pressure and chemical/ soap applications. See Operation section. Chemical Hose (not shown): Allows cleaners or cleaning solvents to be mixed with the pressurized water stream. See How To Siphon Chemicals/Cleaning Solvents in Operation section of this manual. D25806 8- ENG BASIC ELEMENTS OF ENGINE Refer to the engine manual for location and operation of engine controls. Choke Control: Opens and closes carburetor choke valve Throttle Control Lever: Controls engine speed. Starter Grip: Pulling starter grip operates recoil starter to crank engine. Fuel Valve Lever: Opens / closes connection between fuel tank and carburetor. Engine Switch: Enables and disables ignition system pressure washer operating features PRESSURE WASHER TERMINOLOGY NOTE: Become familiar with this terminology before operating. PSI: Pounds per Square Inch. The unit of measure for water pressure. Also used for air pressure, hydraulic pressure, etc. GPM: Gallons Per Minute. The unit of measure for the flow rate of water through the pressure washer. CU: Cleaning Units. GPM multiplied by PSI. Bypass Mode: In Bypass Mode, the pump is recirculating water because the trigger of the spray gun is not pulled. If unit is left in bypass mode for more than two ...

Baixe o seu

Para fazer o download, introduza 2 dígitos :