• Do not let the monitor become overheated. If the temperature in the vehicle is high or the monitor has been exposed to direct sunlight, cool the monitor ( such as, by running the air conditioning ) before you turn it on. • Keep all liquids, including beverages and cleaning fluids away from the monitor. Liquids in the monitor can damage the electronics and result in electrical shock or fire . If the unit becomes wet, turn off all power and contact an authorized Clarion dealer to have the monito

7 English Display mode setting To choose the proper display mode for the different video sources, please refer to display mode setting below. 1. Press MENU several times until you reach the DISPLAY MODE option. 2. Press Ў (down key) or ^ (up key) to select the display mode for: NORMAL, FULL WIDE, and WIDE. 3. WIDE may stretch the image to fill the entire screen, NORMAL displays the image at its true aspect ratio (4: ), FULL WIDE stretches the image horizontally to fit the screen for aspect ratio

A 3.5mm male-to-female stereo extension may also be required if the TTX001 and the VS735 are installed in separate locations (P/N varies by length). • The TTX001 is connected to the VS735 to allow the VS735 to control both audio and video switching. Do not use the Video 2 input of the VMA6593 for the TTX001 in this instance. VMA6593 13 Video input 1 Video input 2 6.5 INCH WIDE LCD MONITOR VMA 6593 DVD VCD CD MP3 DOLBY DIGITAL REMAIN CHP TRK ANGLE REPEAT A B TITLE SCN RDM L / R POWER OPEN IR outp

THIS PRODUCT IS NOT INTENDED FOR VIEWING BY THE DRIVER WHILE THE VEHICLE IS IN MOTION SINCE SUCH USE MAY DISTRACT THE DRIVER OR INTERFERE WITH THE DRIVER’S SAFE OPERATION OF THE VEHICLE AND MAY RESULT IN SERIOUS INJURY OR DEATH. SUCH USE MAY ALSO VIOLATE STATE LAW. CLARION DISCLAIMS ANY LIABILITY FOR ANY BODILY INJURY, INCLUDING FATALITIES, OR PROPERTY DAMAGE THAT MAY RESULT FROM ANY IMPROPER OR UNINTENDED USES OF THIS PRODUCT. INTRODUCTION: The VMA6492 is a TFT active matrix color LCD monitor w

Doing so may damage the vehicle’s battery or the multimedia system. • Do not disassemble or modify monitor. Doing so may damage it and void the warranty. • Keep moisture away from the set. Water and humidity may damage the internal circuitry. • Do not let the monitor become overheated. If the temperature inside the vehicle is high or the monitor has been exposed to direct sunlight, lower the monitor’s temperature before use. (The liquid crystal panel operates within a temperature range of -1~

20 4. INSTALLATION AND WIRING 4. INSTALLATION AND WIRING Read these instructions and the following precautions carefully. What is included in the box In addition to this manual, the box contains: • Either a 5.6” VMA573 or 7” VMA773 monitor unit with wiring harness • One 1.2M RCA A/V cable .. One power cable • One 25cm 3.5. Jack to RCA adaptor cable • Owner’s manual & Installation guide .. Bezel • Metal insert card 21 Before Starting Disconnect the minus(..) terminal on the vehicle’s battery. WAR

Doing so may damage it and voids your warranty. • Keep drinks and drops from umbrellas away from the set. Water may damage the internal circuitry. • Do not let the set become hot. If temperature in the car is high or the set has been exposed to direct sunlight and is hot, lower the temperature before using it. (The liquid crystal panel will work properly within a temperature range of 41° - 104° F.) muaisiuiiiuziu • In extremely cold temperatures, the movement of the picture may be slow and t

The initial factory default setting is the RGB input. NOTE: The LED will be green under normal signal input. If no input signal is detected the monitor will display a flashing error message for that particular source. The LED will turn orange upon entering the power saving mode after five seconds. Choose the proper input source by pressing the Input Select Button on the front of the monitor. NOTE: In some cases, if the RGB, Video, or S-Video signal is low, the LED will turn orange and enter a po

• Keep drinks and drops from umbrellas away from the set. Water may damage the internal circuitry. • Do not let the set become hot. If temperature in the car is high or the set has been exposed to direct sunlight and is hot, lower the temperature before using it. (The liquid crystal panel will work properly within a temperature range of 14°F - 144° F). • In extremely cold temperatures, the movement of the picture may be slow and the picture may be dark, but this is not a malfunction. The set wil

5. The sole responsibility of Clarion Corporation under this Warranty shall be limited to the repair or replacement thereof, at the sole discretion of Clarion Corporation. 6. If it becomes necessary to send the product or any defective part to Clarion Corporation or an authorized warranty service station, the product must be shipped in its original carton or equivalent carton, fully insured, with shipping charges prepaid. Clarion Corporation will not assume any responsibility for any loss or dam