Assessments - 2, GPA: 3.5
(
)
)
|
Facilidade de uso
• Never block the ventilation holes. • Do not attempt to operate this unit, if it becomes damaged in any way. • Never operate this unit when it’s cover is removed. • This unit is for adult use only. Keep out of the reach of children. Copter-Sphere™ Power Supply Power Supply: Before plugging your unit in, be sure the source voltage in your area matches the required voltage for your American DJ ® Copter-Sphere™ before attempting operation. © American DJ Supply ® - - Copter-Sphere™ Instruction Manual Page 3 • Vibrantly Multi Colored • 8 RPM Motor. • Easy Lamp Replacement. • Light Weight, Compact Case Design. • Built-In Mounting Plate. • Bright ZB-64514 120v/300w Lamp • Low Power Consumption (about 2 amps). Copter-Sphere™ Operation Introduction: Thank you for purchasing the American DJ ® Copter-Sphere.™ To optimize the performance of this product, please read these operating instructions carefully to familiarize yourself with the basic operations of this unit. This unit is a modern version of the classic helicopter. The Copter-Sphere™ is a multicolored rotating centerpiece effect. This unit spins at 8 RPM and emits bright and vibrant colorful beams of light. This unit is designed for mobile DJ’s, bands, roller rinks or any arena that requires a compact light. General Operation: Simplicity! Just plug this light in, and watch it go. This fixture is designed to operate as a stand alone unit. It has been tested and the lamp has been installed at the factory there is no assembly necessary. The Copter-Sphere™ is ready to be plugged in, out of the box. There is no power switch, after plugging the unit the unit will slowly light up and rotate in a single direction. If there is no lamp output check the fuse and bulb. If the fuse and bulb are good, please return the unit for servicing. Copter-Sphere™ Halogen Lamp Warning This fixture is fitted with halogen lamps which are highly susceptible to damage if improperly handled. Never touch lamp with your bare fingers as the oil from your hands will shorten lamp life. Also, never move the fixture until the lamps have had ample time to cool. Remember, lamps are not covered under warranty conditions. © American DJ Supply ® - - Copter-Sphere™ Instruction Manual Page 4 Copter-Sphere™ Cleaning Copter-Sphere™ Fuse & Lamp Copter-Sphere™ Cleaning Copter-Sphere™ Fuse & Lamp Caution: Always replace with the exact same type lamp and fuse, unless otherwise specified by an authorized American DJ ® technician. Replace with anything other than the specified part can damage your unit and will void your manufactures warranty. Warning: If after you have replaced the lamp or fuse and you continue to blow either one, STOP using the unit. Contact customer support for further instructions, you may have to return the unit for servicing. Continuing to use the unit may cause serious damage. Fuse Replacement: Disconnect the unit’s main power supply. Insert a standard flat head screw driver in to the fuse holder housing. Turn the screwdriver in counter- clockwise direction to remove the fuse holder. Remove the old fuse and discard it, replace the fuse with the same type. Insert the fuse holder back into it’s housing and turn in clockwise direction to lock the holder in place. Lamp Replacement: Caution! Never open the unit when in use. Always disconnect the main power and allow the fixture ample time to cool before attempting to replace the lamp. Lamp replacement has been made simple by incorporating a split dome that is retained by thumb screws. Again, please remember to always replace with the exact same type lamp. 1. Be sure to follow the proper procedures when handling halogen lamps. Never touch the new lamp with your bare fingers. 2. Locate the lamp cover assembly on the top of the unit and remove the two thumb screws on that secure the lamp cover to the unit. Remove the lamp cover to expose the lamp socket assembly. 3. Carefully pull up the upper half of the dome to expose the lamp. 4. Remove and replace the lamp. 5. Reassemble in reverse order. Copter-Sphere™ Warranty Registration The Copter-Sphere™ carries a 90 day limited warranty. Please fill out the enclosed warranty card to validate your purchase. All returned service items whether under warranty or not, must be freight pre-paid and accompany a return authorization (R.A.) number. If the unit is under warranty you must provide a copy of your proof of purchase invoice. Please contact American DJ ® customer support for a R.A. number. © American DJ Supply ® - - Copter-Sphere™ Instruction Manual Page 5 Fixture Cleaning: Due to fog residue, smoke, and dust cleaning the internal and external lenses should be carried out periodically to optimize light output. 1. Use normal glass cleaner and a soft cloth to wipe down the outside casing. 2. Clean the external optics with glass cleaner and a soft cloth every 20 days. 4. Clean the internal optics with glass cleaner and a soft cloth every 30- 60 day...