Assessments - 4, GPA: 4.3
(
)
)
|
Facilidade de uso
Inspection and repairs Before use, check the appliance for damaged or defective parts. Check for breakage of parts, damage to switches and any other conditions that may affect its operation. The following safety symbols are marked on your spotlight: Warning! To reduce the risk of injury, the user must read the instruction manual. Warning! Do not touch the lens as it becomes very hot during operation and remains hot for several minutes after the spotlight is switched off. Warning! Burn hazard. Hot lens may cause property damage or fire. Do not touch or obstruct the lens. Allow the spotlight to fully cool down before storage or charging. Keep combustible materials away from spotlight lens. Extreme heat can cause fires. Never place the light face-down on any surface when it is switched on or cooling. Do not leave the spotlight unattended. Keep children and animals away from the work area. Inspect the lens for damage following impact or if the spotlight is dropped. Do not operate without the lens in place or with a damaged lens. The lens is manufactured from glass. The lens may crack or break if subject to an impact. If the lens is damaged it must be replaced by manufacturers original parts. Wear gloves as sharp edges may cause injury. Never look directly into the light or shine the light into another person's eyes. Do not immerse spotlight in water. Additional safety instructions for batteries and chargers Batteries Never attempt to open for any reason. Do not charge damaged batteries. Do not expose the battery to water. Do not expose the battery to heat. Do not store in locations where the temperature may exceed 40°C. Charge only at ambient temperatures between 4°C and 40°C. Charge only using the chargers provided with the tool. When disposing of batteries, follow the instructions given in the section "Protecting the environment". 11 ENGLISH Chargers Your charger has been designed for a specific voltage. Always check that the mains voltage corresponds to the voltage on the rating plate. Warning! Never attempt to replace the charger unit with a regular mains plug. Use your Black & Decker charger only to charge the battery in the tool with which it was supplied. Other batteries could burst, causing personal injury and damage. Never attempt to charge non-rechargeable batteries. Have defective cords replaced immediately. Do not expose the charger to water. Do not open the charger. Do not probe the charger. The spotlight must be placed in a well ventilated area when charging. All batteries lose charge with time, specially when they are warm. Recharge the unit every two months for 24 hours when not in frequent use. If the unit is not going to be used for extended periods, disconnect the charger and store in a cool, dry place. Warning! Use only the supplied charger when charging the spotlight. The use of any other charger could damage the spotlight or create hazardous condition. The following symbols are found on your charger: Your charger is double insulated; therefore no earth wire is required. Read all of this instruction manual carefully. This appliance is intended for indoor use only 130oC The charger automatically shuts off if the ambient temperature becomes too high. As a consequence the charger will be inoperable. The charging base must be disconnected from the mains supply and taken to an authorised service centre for repair. This product must not be disposed of with normal household waste. Electrical safety Your charger is double insulated; therefore no earth wire is required. Always check that the main voltage corresponds to the voltage on the rating plate. Warning! If the power cord is damaged, it must be replaced by the manufacturer, authorized Black & Decker Service Center or an equally qualified person in order to avoid damage or injury. If the power cord is replaced by an equally qualified person, but not authorized by Black & Decker, the warranty will not be valid. FEATURES This appliance includes some or all of the following features: 1. Carry handle 2. 2 Position brightness switch (high and low setting) 3. Charging LED indicator 4. Carry lanyard 5. Trigger lock 6. Pistol grip 7. On/off trigger switch 8. Charging socket 9. Quartz halogen bulb 10. Charger jack plug 11. Mains charger adaptor Charging the spotlight (fig. A & B) This spotlight is shipped in a partially charged state. Charge the spotlight before first use using the mains charging adaptor (11) for 24 hours or until the green charging LED (3) lights. Charge after each use until the green charging LED indicator (3) lights. The LED (3) indicates the battery level whilst charging. One red LED indicates that the unit requires charging. Two red LEDs indicate a high level of charge remaining. The green LED lights shows the unit is fully charged. Charging with the mains charger (fig. B) Make sure that the spotlight is off (the trigger lock (5) is in the off position and the trigger (7) is not pressed). Note: To ensure optimum battery life do not...
Este manual também é adequado para os modelos :Iluminação - BSL302 (5.24 mb)