Assessments - 1, GPA: 5
(
)
)
|
Facilidade de uso
LCD Display 2. DC Power Jack 3. Battery Compartment Cover (bottom) 4. Play/Pause Button 5. Volume Control 6. CD LID Button 7. Headphones Jack 8. Stop Button 9. Next Button 10. Previous Button 11. Mode Button 12. Program Button 13. CD Door This CD player operates on two 1.5V DC ‘AA’ size (UM-3) alkaline batteries ( not included) or with an AC adaptor with an output of 4.5VDC/700mA (not included). To install batteries into the player 1. Open the battery compartment cover located on bottom of cabinet. 2. Insert two 1.5V DC ‘AA’ size (UM- 3) alkaline batteries ( not included) into the Battery Compartment following the polarity markings as indicated in the compartment. 3. Close the battery door and completely slide it back to its original position. Battery care i. Be sure that the batteries are installed correctly. Wrong polarity may damage the unit. ii. (a) Do not mix old and new batteries. (b) Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickelcadmium) batteries. iii. If the unit is not to be used for an extended period of time, remove the batteries. Old or leaking batteries can cause damage to the unit and may void the warranty. iv. Never attempt to charge “ Non-rechargeable” batteries. v. Do not dispose of batteries in fire, batteries may explode or leak. Using an adaptor ( not included) to power the player 1. Before connecting the adaptor to the player, make sure that the AC voltage of the adaptor corresponds to your local AC outlet voltage. The polarity of the adaptor must match to the polarity markings next to the DC jack on the player. 2. Plug the 4.5VDC/700mA AC-DC adaptor into an AC outlet. 3. Insert the DC plug into the jack on the player. NOTE: When the adaptor is connected, the batteries will be automatically disconnected and the player will now operate on the adaptors power. Once the adaptor is unplugged the player will automatically switch to back to battery power. EN- 4 EN-5 EARPHONES CONNECTION EARPHONES CONNECTION Connect the plug of the stereo earbuds (included) into the PHONES socket. CAUTION • AVOID EXCESSIVE VOLUME LEVELS FOR LONG PERIODS OF TIME WHEN USING THE HEADPHONES. PROLONGED USE AT HIGH LEVELS MAY IMPAIR YOUR HEARING. • Do not use earphones while operating a motorized vehicle, as it may create a traffic hazard and is illegal in many areas. BASIC OPERATION NOTE: This unit can also play 3 inch (8cm) single CDs without an adaptor. Do not use a CD single adaptor for these smaller discs. 1. Press the CD LID OPEN button to release the CD lid. 2. Insert a disc with the label side facing up. 3. Close the CD Lid. A click will be heard when it locks into place. 4. Press the PLAY/PAUSE button once to start playing. 5. The display will show the total number of tracks and playing time. The player will then start playing the first track. 6. Adjust the volume by turning the Volume Control. Locating a Particular Track To skip back to the beginning of the Press once or repeatedly. current or a previous track To skip to the beginning of following Press once or repeatedly. tracks Locating a Particular Point in a Track To search back at a high speed Press & hold To search forward at a high speed Press & hold EN- 6 Turning Power On and Off To turn ON and OFF, press the following buttons after a disc is inserted into the player. To turn ON: Press PLAY/ PAUSE button (playback starts) To turn OFF : Press STOP button once for standby mode. Press STOP button again to turn off the power. Auto power- off function When the unit is stopped (Standby mode) for approximately 30 seconds, the power is automatically turned off. To Remove the Disc 1. Press the CD LID OPEN button to open the CD compartment lid. 2. Hold the edge and gently press the center pivot as illustrated, then pick up the disc. CAUTION: WAIT FOR THE DISC TO STOP SPINNING BEFORE SLIDING THE OPEN SWITCH AND OPENING THE LID. LCD DISPLAY INFORMATION When the button is pressed at initial start up • The display will show “ - - “ and then the total number of tracks and total playing time. The disc will start playing and the display will show the first track number and instant playing time. • To review the total number of tracks and total playing time of the disc, press the STOP button once. During PLAY mode • The track number and instant playing time are displayed. During PAUSE mode • When the track playback is paused, the playing time flashes. Battery Low Indicator A flashing battery indicator flashes in the display when the batteries need to be changed. EN-7 NORMAL PLAYBACK VARIOUS PLAYBACK MODES VARIOUS PLAYBACK MODES NORNAL PLAYBACK The whole disc is played and the player will stop after the last track is finished. Every time the MODE button is pressed, the corresponding mode appears in the display window, in the following sequence: REPEAT 1 In stop or playback mode press the MODE Button once. When shown on the LCD display, the current track on the disc will be repeated. REPEAT ALL In stop or playback mode press the MODE Button twice. ...
Este manual também é adequado para os modelos :Jogadores - CD-36 (166.46 kb)