Assessments - 3, GPA: 4.3
(
)
)
|
Facilidade de uso
*NOTE: Trim Kit and microwave can only be built-in over an electric self-clean or non self-clean single cavity wall oven. CABINET OR WALL CUTOUT Cutout Dimensions Height (A) Minimum Maximum 16 3/4” (42.5 cm) 17” (43.2 cm) Width (B) Minimum Maximum 24 3/4” (62.9 cm) 25” (63.5 cm) Depth (C) Minimum 20” (50.8 cm) Illustration 1 Screw A Screw B Front Frame Assembly Exhaust Dust Assembly fig2.jpg Illustration 2 ELECTRICAL OUTLET LOCATION Outlet should NOT be in the shaded area as indicated on Illustration 2 NOTE 1: If the Depth (C) dimension is greater than 21” (53.3 cm), the outlet location may be in any area on the rear wall. NOTE 2: The floor of the opening should be constructed of plywood strong enough to support the weight of the oven and floor load (approximately 100 pounds). The floor should be level for proper operation of the oven. Be sure to check the local building code as it may require that the opening be enclosed with side, ceiling and rear partition. The proper functioning of the oven does not require the enclosure. fig3.jpg Illustration 3 EXHAUST DUCT ASSEMBLY 1. Place the Exhaust Duct in the opening. When the Exhaust Duct Assembly is in the opening correctly, the flanges will be tightly against the lower edge of the opening. See Illustration 3. 2. Secure the Exhaust Duct Assembly with the two screws A. IMPORTANT: Secure screws in outer hole. Screw A Screw A Exhaust Dust Assembly Flanges FRAME INSTALLATION 1. Place the oven adjacent to the wall or cabinet opening. Plug the power cord into the electrical outlet. 2. Carefully guide the assembled oven into the prepared opening. Slide the oven on the Exhaust Duct Assembly. See Illustration 4. Avoid pinching the cord between the oven and the wall. Adjust the position of the oven so that the feet of the oven are fitted into the recesses of the Exhaust Duct Assembly. See Illustration 5. 3. Position the FRAME ASSEMBLY to be square with the oven. Carefully place the FRAME ASSEMBLY on the oven. Check that it is level and then secure with two SCREWS B. See Illustration 6. 4. Secure the bottom portion of the FRAME ASSEMBLY with the two remaining SCREWS B. See Illustration 6. fig4.jpg Illustration 4 fig5.jpg Illustration 5 fig6.jpg Illustration 6 Exhaust Dust Assembly Screw B Screw B Screw B Screw B Races Foot Instructions d'installation Instructions d'installation Ensemble de garnitured'encastrement MWTK(P)27K et MWTK(P)30K AVANT DE COMMENCER . IMPORTANT – Conserver ces instructions a l’usage de l’inspecteur local. . IMPORTANT – Respecter tous les codes et reglements regissant une telle installation. . Note destinee a l’installateur – S’assurer de laisser ces instructions au consommateur.. . Note destinee au consommateur – Conserver ces instructions pour reference ulterieure. . Niveau de competences – L’installation de cet appareil exige des competences elementaires en mecanique et en electricite. Lisez ces instructions attentivement et au complet : . L’installateur est responsable de l’installati...
Este manual também é adequado para os modelos :Placa - MWTK(P)27K (1.49 mb)