Only the CANCEL/SECURE and the oven light keys remain functional. • To reactivate the control panel, press and hold the CANCEL/ SECURE key for four seconds. • 12 Hour Timer Feature Your range is equipped with a feature that automatically turns the oven off after 12 hours of continuous use. The 12 hour timer resets if you change the cooking temperature or cooking mode. This feature does not apply to the cooktop. The range ships from the factory with the 12 hour timer enabled. To disable or enable

• Do not allow foods to remain in the oven after it turns completely off (after hold mode.) When the temperature drops below 140°F, bacteria can develop. • If cooking will not begin immediately, place only very cold or frozen food into the oven. Most unfrozen foods should never stand in the oven for more than two hours before cooking begins. Delay Timed Cooking Set-up Before Setting the Controls: • Adjust the racks to the appropriate level. • Put the food in the oven. The Three Ways to Use Delay

ALL DACOR APPLIANCES ARE DESIGNED AND CONSTRUCTED TO GIVE YOU MANY YEARS OF SAFE OPERATION. THE OPERATION WILL BE FURTHER ENHANCED IF PROPER CARE AND JUDGEMENT ARE EXERCISED IN THE USE AND MAINTENANCE OF THIS APPLIANCE. WARNINGS: Must be followed carefully to avoid personal injury or damage. NOTES: Contains helpful hints and tips. Place Serial Number Label Here Use & Care Epicure™ Ranges Please Read Before Using Your Range Part No. 65091 Rev. G 1 TABLE OF CONTENTS ...............................

7. When the time expires and/or the food is done cooking, press the “CANCEL•SECURE” pad to turn off the oven. Securing Controls To avoid accidentally turning the oven on, activate the “SECURE” feature. Press and hold the “CANCEL•SECURE” pad for approximately three seconds. This will disable the control panel and allow cleaning the controls without accidentally starting any functions. Three beeps will sound and “OFF” will appear in the display when the control panel has been secured. To re-activa

Verify that local building codes will permit installing the gas valve behind the range. A manual shut off valve must be installed in the gas piping, external to the appliance, for the purpose of turning on or shutting off gas to the appliance. Plan the location of the range and the gas supply to allow access to the valve when the unit is installed and in operation. Access to the remote circuit breaker panel/fuse box, with the range in place and operating, must also be allowed for in the installa

C. Connecting the Green Appliance wire to a Grounded Supply wire or a Grounded Cold water Pipe – where Local Codes Permit. (All Models) 1. Separate the green and white appliance wires. 2. Connect the white appliance wire to the neutral (white) supply wire in the junction box. 3. Connect the black appliance wire to the black (L1) power supply wire in the junction box. Cable from 4. Connect the red appliance wire to the red (L2) power supply wire in the junction box. 5. Connect the green appliance

CONVENTIONS USEd IN ThESE INSTRUCTIONS IMPORTANT NOTES: Contain helpful hints and tips to facilitate the installation. wARNINGS: Must be followed carefully to avoid personal injury or damage. 1. Before beginning installation, please thoroughly read and become familiar with these instructions. 2. Installation and service must be completed by a qualified installer or service agency. 3. Installer: Please leave these Installation Instructions with the owner. 4. Owner: Please keep these instructions

It may rock back and forth slightly, which is normal. Set one of the burners under the grill to the light (high) position. Once lit, turn the knob to the MAX GRIDDLE position, or lower if desired. DO NOT keep the burner knobs higher than the MAX GRIDDLE setting after they are lit! Repeat Step 3 for the other burner under the grill. During cooking be careful with metal utensils on the surface because they can scratch the nonstick coating. See back for cleaning instructions. Cleaning the Grill

Warm water and liquid detergent are all that are needed for cleaning. Remove stubborn spots with a non-abrasive plastic mesh pad. To prevent scratching, do not use abrasives or abrasive cleaners. STEP 3: STEP 4: STEP 5: MAX GRIDDLE Grease trap toward back Line up bottom of grill with top of grate EG366 and EG486 Put over center burners Page 2 Grill Placement and Use ER36D and ER48D Put over center burners "^Tj CAUTION: For grills used with model ER30G, the kit comes with two extra

Use baking soda or a foam extinguisher to extinguish flaming grease. Be careful to avoid getting burned. IA1 WARNING: Non-stick coatings, when heated, can be harmful to birds. Remove birds to a separate, well-ventilated room during cooking. OS CAUTION: Place the grill only in the position shown below. Do not turn the burners under the grill higher than the “MAX GRIDDLE” setting. Setting the burner flames too high or putting the grill in the wrong position may damage it permanently. Part No. 1