(519) 650-5775 or Fax (519) 650-3773 Toll Free Phone 1-800-361-1517 Toll Free Fax 1-800-327-5609 #3937 032205 © 2005 HEARTLAND APPLIANCES INC. Note: Please read these instructions thoroughly before attempting to install this unit. Failure to follow installation instructions will result in costly service calls. This appliance can only be installed in the state of Massachusetts by a Massachusetts licensed plumber or gasfitter. Save these instructions for future use Model 3530-3630 Model 3535-3635

5200 48" Gas Top / Electric Convection Range 5210 48" Gas Top / Electric Convection Self Clean Range 4200 30" Gas Top / Electric Convection Range 4210 30" Gas Top / Electric Convection Self Clean Range Model 5200/5210 NOTE: Clock must be set or your main oven will not function! Model 4200/4210 ATTENTION INSTALLER: Leave this manual with appliance The oven door thermometer does not sense temperature. It is for aesthestics only and is nonfunctional. © 2004 HEARTLAND APPLIANCES INC. WARNING: Improp

Have the installer show you the location of the circuit breaker or fuse. Mark it for future reference. 2. Never use your appliance for warming or heating the room. Use only for its intended use as described in this manual. 3. Do not leave children alone. Children should not be left alone or unattended in area where appliance is in use. Children should never be allowed to sit or stand on any part of the appliance. 4. Do not allow children to play with controls or any part of appliance. 5. Do not

Broil Diagram shows how element will not turn on when bake element is used. heat is radiated from the elements, during the cooking process Convection Cooking: Convection means conveying. A fan at the back of the oven circulates the hot air thus Convection Air Pattern cooking foods from all sides, sealing in juices. The circulating air penetrates food faster Diagram shows how heat is therefore you may want to cook foods for less time at the usual temperature or reduce circulated from the convecti

The bulb can then be unscrewed easily. Always handle the bulb with a dry (never wet) cloth to protect hands. If light bulb should break, disconnect power to range by unplugging it or removing the fuse from the panel before touching the bulb. When replacing the bulb, use only a 40 watt oven bulb available at your local hardware store or appliance dealer. When cleaning the oven, do not touch lens with a wet cloth. 27 Surface Burners Top burners require little care other than to wipe off the head o

Screw will back off enough to open door.It is not possible to open lower door without first opening upper door. (See Figure 2) To close the doors. Close both doors tight and use utensil to tighten both door release screws clockwise. Ensure both doors are secured tight so that no air will be able to fuel the fire through the fire doors. Do not slam the fire door shut! Lighting the Fire a) Check the flue pipe is free of blockage. b) Open firebox door. c) Open ashpit door. d) De-ash and remove dead

Note: Please read these instructions thoroughly before attempting to install this unit. SAFETY NOTICE: If this stove is not properly installed, a house fire may result, for your safety, follow the installation directions, contact local building or fire officials about restrictions and installation inspection requirements in your area. IMPORTANT: Check around oven chamber on a weekly basis for soot and creosote accumulation. Clean the chamber thoroughly from the top, side and bottom with the rake

5200, 5210, 4200, 4210, 6200, 6210, 8200, 8210, Exhaust Hood Recptacle Locations When installing the multi-pin plugs, make sure the flat sided pins are aligned with flat sided holes. Each plug is coded for proper fit. Do not force plug into receptacle. Insert themulti-pin plugs into corresponding receptacles- each plug is coded to match its receptacle. Loop power cord on back and attach power cord to stove back with supplied cable tie and screw Plug the stove into wall receptacle. Check all elec

-Remove small box and its contents. -Remove the cardboard cross brace. -Remove the plastic wrapped cresting panel. 2 Assembly of Cresting Panel. Main Cabinet Cresting PanelWingnut view of top of cabinet Locate cresting panel packed in bubble wrap. Unwrap the cresting panel and remove the wingnuts. Place the cresting panel on the rear of the top of the cabinet. Take the wingnuts and fasten the cresting panel to the cabinet through the holes at each end of the cabinet. For: WOOD STOVES - go throug

-Place box on the floor close to stove. (See Fig. 1 Page 2). -With a helper,lift cabinet assembly from box by area that is circled.(See Fig.1 Page 2). -Rest the cabinet assembly on the carton,while your helper steadies the cabinet,peel the cabinet backing off the gasket and stick one on each bracket. -Place cabinet assembly onto stove body.(See diagram above) -Line up holes in the bottom (foot) of the bracket with the holes in the stove top,while one person supports the cabinet, fasten the cabin