Assessments - 3, GPA: 4
(
)
)
|
Facilidade de uso
The drain connected to the main pump by hose. The drain check valve is located discharge end of the drain pump. The is attached by a clamp to the discharge the drain pump. Heater Refer to the cycle chart on the reverse side to determine when the heater is on during the wash cycle. The heater cycles ON and OFF for brief periods during the drying cycle. Standard Dry Air Flow The heated, moist air leaving the dishwasher through the console vent causes drier air to be drawn into the unit by way of intake vents located at the bottom of the door. Detergent and Rinse Aid Dispenser The detergent and rinse aid dispenser is a one piece component consisting of a molded detergent cup and a built-in rinse aid dispenser. The detergent cup has a spring loaded cover and the rinse aid dispenser has a removable cover. Liquid rinse aid is added to the dispenser up to the fill line indicator. The amount of rinse aid released can be adjusted by turning the arrow indicator from one, being the least amount, to four, being the greatest amount. The drain hose minimum height of 32 inches in order to insure drainage. Voltage checks of the heater should be made in the dry portion of the service test mode. The water on the dishes is evaporated into drier air and the venting process continues. The heating element is turned ON and OFF during the entire drying cycle. To replace dispenser: • shut off electricity to dishwasher, • remove outer door panel assembly, • disconnect wiring to the actuator, • remove the six screws, • remove the dispenser, • replace and reinstall screws, • rewire actuator. Product Electrical Rating................................... 120 Volts, 60Hz Separate Circuit..15 Motor (Amps) ................................... 0.6 - 0.9 Heater Wattage .......................... 475 - 630W Total Amps (load rated) .......................... 7.0TempAssure .............................. 135° F ±5°F(60°C±3°C) [with outer door in place] TempBoost ................................ 140°F ±5°FHeated Wash/Heated Rinse Hi-Limit Thermostat ............... 200°F ( 93°C) Water Supply Suggested minimum temperature ............................ 120°F (49°C) Pressure (PSI) min./.................. 20/120 Connection (NPT) ..................................... 3/8" Consumption ( Normal Cycle) ..................... . .......................................... 5.2 - 5.6 U.S. gal Water valve flow rate (U.S. GPM) ............ 0.9 Water recirculation rate ( U.S. GPM) ............. . ................................................. approx. 5.28 Water fill time ................................... 36 sec. Trouble Always disconnect the dishwasher orreplacing components. Personal Injury Hazard Symptom Check the Following Remedy Dishwasher will not operate whenturned on. 1. Fuse (blown or tripped). 2. 120 VAC supply wiring connection faulty. 3. Electronic control board defective. 4. No 12 VAC power to control. 5. Motor (inoperative). 6. Door switch (open contacts). 7. Door latch not making contact with door switch. 8. Touch pad circuit defective. 9. No indicator lamps illuminate when START or OPTIONS are pressed. 1. Replace fuse or reset breaker. 2. Repair or replace wire fastene...
Este manual também é adequado para os modelos :Máquinas de lavar louça - FDB2410HIC (189.42 kb)