Assessments - 2, GPA: 3.5
(
)
)
|
Facilidade de uso
NOTE: The rubber sink flange seal should always be used where possible. In rare instances where the contour or thickness of the sink opening does not permit use of the seal. a permanently pliable sealing compound may be used. THE SINK FLANGE MUST BE LEVEL BEFORE MOUNTING DISPOSER. 6. Assemble the second sink flange seal (3), pressure washer (4) and support plate (5) onto the sink flange and lock in place with snap ring (6). Tighten the three ,jack screws (13) EVENLY against pressure washer (4) to secure the mounting assembly to the sink. DISHWASHERCONNECTION(IF APPLICABLE) Connecting the discharge of a dishwasher to a disposer will assure all waste particles discharged by the dishwasher are properly sized and flushed through to the main drain system. A dishwasher drain inlet that will accept a 3/4” I.D. hose fitting is provided in the side of the upper housing grinding chamber for connection of the dishwasher discharge, 1. Use a small cold chisel or punch to cut out the back wall knockout of the dish- washer inlet boss of the disposer. 2. Turn the disposer upside down to remove any pieces or chips from the grinding chamber. 3. KD-100, KD-200. & KWC-2OOB MODELS -Where plumbing codes require, a 3/4” galvanized pipe fitting may be substituted for the plastic fitting (13) provided. Whel-e plumbing codes permit, use a rubber hose sleeve connection to prevent transmission of normal operating noise. NOTE: .A11 connections must be in accordance ivith local plumbing codes, DISPOSER INSTALLATION / 1. Be sure the isolating splash guard (8) is in place. Lift disposer and engage hooh (7) onto support plate (4), then engage hook (11) onto support plate (4). Turn disposer to align with drain trap. Snap lever (10) downward to lock. 2. Connect the drain trap to the spout (9). If necessary. pry lever (10) outward and turn disposer for better alignment. 3. Connect the dishwasher drain hose to the disposer inlet (13) with a hose clamp (where applicable). 4. Check to assure that the grinding chamber is clean of any foreign objects and tire flywheel is free to rotate, Place the cover in position and fill the sink at least three inches deep. Remove the cover and, as the water drains. chech all con nections for leaks TYPICAL INSTALLATIONS Height of drain must not exceed height of disposer discharge opening. Typical “P” Trap Connection Connection With Straight-Away Drain Spout WARNING: DISCONNECT ELECTRICAL POWER SUPPLY AT THE FUSE/ CIRCUIT BREAKER BOX BEFORE MAKING ELECTRICAL CONNECTIONS. Follow the National Electrical Code and/or your local electrical code in all details. In older houses with limited circuits, or if it appears the circuit is heavily loaded, run a line directly to the main fuse box. 1. Remove the electrical access cover on the bearing bracket assembly. 1,. Install standard strain relief connector (not furnished) into threaded opening in bearing bracket assembly. 3. Install the control switch where it is easily accessible for the owner. Recom- mended: On...
Este manual também é adequado para os modelos :Outros aparelhos de cozinha - KD-100 (169.94 kb)
Outros aparelhos de cozinha - KD-200 (169.94 kb)