Assessments - 3, GPA: 4
(
)
)
|
Facilidade de uso
Sink flange assembled in center of drain opening and tightly sealed. 0 3. Disposer level -not installed at an angle. 0 4. If a dishwasher drain is connected into the disposer, check to assure that the inlet knockout has been removed. PLUMBING 0 1. If installed in old house, existing drain line from sink to sewer cleaned. 0 2. Long, horizontal drain lines eliminated. 0 3. Drum traps and grease traps should not be used. 0 4. Seal at drain spout properly positioned. 0 5. Center line height of drain line must not exceed center line height of disposer discharge opening. 0 6. M oun t’mg screws and spout screws properly tightened to prevent leaks. 0 7. Compliance with all aspects of local plumbing code. ELECTRICAL CONNECTION 0 1. Properly fused, 115 volt, 60 hertz branch circuit of 15 ampere capacity. 0 2. Disposer properly grounded before operating. 0 3. All connections must comply with the National Electrical Code and/or local electrical code. OPERATIONAL 0 1. Before operating, check to assure grind chamber is free of any foreign objects. 0 2. Activate disposer -test for grinding performance and water leaks. THANK YOU INSTALLER: 1. Complete Installation Check List. 2. Leave all literature (including Check List) for customer. 3. Notify dealer that electrical work and plumbing are completed. GENERALINSTRUCTIONS 1. In old houses it 1s generally wise to clean out the existing dram line from sink to sewer before installing the disposer. -.’ The disposer can be installed in a steel. monel, stainless steel, or cast iron sink having a smh openmg of 3-l/2” to 4” without sink alteration. 3. Standard l-l/3” O.D. or 2” O.D. drain pipe is satisfactory for drain lines. Long horizontal drain lines should be eliminated. Drum-traps and grease traps should not be used. SINKFLANGEASSEMBLY 1 Remove disposer cover (1 ). 2. lnserr screwdriver under lever (10) and pry outward. Disengage hooks (11) and (7) from support plate (5). 3. Remove existing sink drain connections and clean drain opening. 4. Disassemble items 2. 3. 4, and 5 of mounting assembly by prying snap ring (6) from groove in sink flange (7). 5. Fil the sink tlange seal (14) to the sink flange (1). Insert sink flange into drain opening. Be sure the sink flange is located in the center of the drain opening to assure a water-tight seal. NOTE: The rubber sink flange seal should always be used where possible. In rare instances where the contour or thickness of the sink opening does not permit use of the seal. a permanently pliable sealing compound may be used. THE SINK FLANGE MUST BE LEVEL BEFORE MOUNTING DISPOSER. 6. Assemble the second sink flange seal (3), pressure washer (4) and support plate (5) onto the sink flange and lock in place with snap ring (6). Tighten the three ,jack screws (13) EVENLY against pressure washer (4) to secure the mounting assembly to the sink. DISHWASHERCONNECTION(IF APPLICABLE) Connecting the discharge of a dishwasher to a disposer will assure all waste particles discharged by the dish...
Este manual também é adequado para os modelos :Outros aparelhos de cozinha - KD-200 (169.94 kb)
Outros aparelhos de cozinha - KWC=200B (169.94 kb)