Remove the bag. See page 9. 2. Wear protective gloves. There may be bits of glass in the drawer. Press the side door latch down. 3. Hold the side door latch and tilt the side of the drawer until the latch clears the drawer front. The drawer side can be removed by tilting and sliding it out. 4. Wash with a damp cloth using warm, soapy water. Rinse and then dry with a soft cloth. 5. If the drawer side was removed, slide it back into the tilted position. 6. Press the side door latch down while pres

It may be located in any convenient space under a countertop. - DO NOT OPERATE FREE-STANDING because the compactor will tip over when the drawer is pulled out. Additional Specifications: A 115 Volt, 60 Hz. power supply is required. An individual properly grounded branch circuit protected by a 15- or 20-amp circuit breaker or time delay fuse is recommended. Install a properly grounded 3-prong electrical receptacle recessed into the back wall. Electrical outlet location is critical for proper c

4. Insert the bottom tabs of the air filter cover and push in until the side tabs snap into place. Cleaning Before cleaning the compactor, turn the Key-Knob (or Key-Switch) to the OFF & LOCK position and remove it. NOTE: Any services other than those outlined in this section should be performed by a designated service representative. Cleaning Exterior Surfaces 1. Wash exterior surfaces (including stainless steel) with a clean sponge or soft cloth and a mild detergent in warm water. Do not use ab

2 INSTALLATION INSTRUCTIONS................................................................... 3 Unpacking ..........................................................................................................................3 Location Requirements ...............................................................................................4 Electrical Requirements ..............................................................................................4 Undercounter Installation.....

Check to be sure that oven supports above the Warming Drawer location do not obstruct the required interior 23-1/2" depth and 9-1/4"height. 10-1/2" t 9" ^-2x4 or 2x2- Runners or Solid Bottom Including Handle Install '2x4 or 2x2 Anti-Tip Block Against Rear Cabinet Wall 9" From Floor to Bottom of Block Undercounter Installation (in inches) Note: When installing warming drawer with a cooktop, allow a 2" minimum from cooktop burner box bottom to top of cut-out. Important Installation Note:

It may be located in any convenient space under a countertop. DO NOT OPERATE FREE-STANDING because the compactor will tip over when the drawer is pulled out. Additional Specifications: A 115 Volt, 60 Hz. power supply is required. An individual properly grounded branch circuit protected by a 15- or 20-amp circuit breaker or time delay fuse is recommended. Install a properly grounded 3-prong electrical receptacle recessed into the back wall. Electrical outlet location is critical for proper cord

Dimensions and clearances A – 34" (864 mm) adjustable to 35" (889 mm) B – 12" (305 mm) C – 20-1/4" (514 mm) D – 22" (559 mm) E – 2-3/4" to 4-1/4" (70 mm to 108 mm) base is adjustable from front panel Note: If cord is to be plugged in directly behind compactor add 2-1/2" to overall depth in order to allow proper clearance for the electrical cord. Installation Preparation Built-In Compactors Standard Appearance Panel Options The Monogram compactor models ZCG3300 and ZCG3100 come with a white/black

adj. to 35" max. This Monogram compactor has a black control panel. The adjustable base allows the toekick depth to match surrounding cabinetry. This compactor is designed as a built-in appliance only. It may be located in any convenient space under a countertop. DO NOT OPERATE FREESTANDING because the compactor will tip over when the drawer is pulled out. Additional Specifications A 115 Volt, 60 Hz. power supply is required. An individual properly grounded branch circuit protected by a 15-

Before installing, consult installation instructions packed with product for current dimensional data. Warranty Information: Full one-year warranty, in-home service, parts and labor.* Full five-year warranty, parts and labor on the compressor, evaporator and all connecting tubing.* *See written warranty for complete details. Note: The addition of a 3/4" thick front panel will result in a front to back depth of 24-1/16". For answers to your Monogram® GE Profile Performance Series,™ GE Prof

Before installing, consult installation instructions packed with product for current dimensional data. Warranty Information: Full one-year warranty, in-home service, parts and labor.* Full five-year warranty, parts and labor on the compressor, evaporator and all connecting tubing.* *See written warranty for complete details. Note: The addition of a 3/4" thick front panel will result in a front to back depth of 24-1/16". For answers to your Monogram® GE Profile Performance Series,™ GE Prof