Installation Starck only Remove the valve mounting nuts from the valves. Push the valves up into the holes. Install the mounting nuts on the valves. Tighten the tensioning screws. Place the handles over the valve mounting nuts. Tighten the handles by rotating the escutcheons clockwise. The handles should be parallel to the basin. Install the spout Position the sealing ring, escutcheon, and spout on the mounting surface. Install the mounting flange. Thread the collar onto the stud and tighten. Sc

Thread the collar onto the stud and tighten. Terrano 37136XX1, Phoenix only Position the spout and sealing ring on the mounting surface. Install the mounting flange. Thread the collar onto the stud and tighten. Install the connecting hoses Push a 3/8" compression nut and ferrule over the end of the connecting hose. Push the end of the hose into the valve outlet. Tighten the compression nut wrench tight. Use two wrenches. Do not allow the connecting hose to twist, or it will become loosened from

water pressure Recommended hot water temp. Max. hot water temp Hole size - spout Hole size - valve Max. mounting surface depth Flow rate -- 17104/17105 only Flow rate -- all other models Terrano 37135XX1 14.7 - 72.5 psi 147 psi 120° - 140° F* 176.F* 1-3/8" 1-1/4" see diagrams 1.5 gpm max. 2.2 gpm max. Requires 1/2" hot and cold supply hoses -- not included Installation Considerations • For best results, Hansgrohe recommends that this unit be installed by a licensed, professional plumber. • Pleas

Max. hot water temp Hole size - spout Hole size - valve Max. mounting surface depth Flow rate -- 17104/17105 only Flow rate -- all other models Terrano 37135XX1 14.7 - 72.5 psi 147 psi 120° - 140° F* 176.F* 1-3/8" 1-1/4" see diagrams 1.5 gpm max. 2.2 gpm max. Requires 1/2" hot and cold supply hoses -- not included Installation Considerations • For best results, Hansgrohe recommends that this unit be installed by a licensed, professional plumber. • Please read over these instructions thoroughly b

120.. - 140.. F* Max. hot water temp 165..F* Hole size in mounting surface valves 1-1/4" spout 1 3/8" Max. mounting surface depth 1 3/8" Flow rate 2.2 gpm *Please know and follow all applicable local plumbing codes when setting the temperature on the water heater. Installation Considerations For best results, Hansgrohe recommends that this unit be installed by a licensed, professional plumber. Please read over these instructions thoroughly before beginning installation. Make sure that you have a