Assessments - 0, GPA: 0 ( )

Fabricante : Philips Arquivo Tamanho: 1.01 mb Arquivo Nome : Língua de Ensino:

- Adjust the height of the rod by pulling or pushing the handle (fig. 13). - Turn the height adjustment knob clockwise until tight to lock the rod (fig. 14). 2 3 4 5 6 1 1 2 8 9 10 11 20 40 12 13 7 14 How to use Replacing the tube lamps and/or starters -Check the distance between your body and the solarium (min. 20 cm or 8"). If necessary adjust the height and/or position of the solarium. -Set the timer to the session time (fig. 15). (Please refer to the table in these instructions and to your own notes.) -Do not forget to put on the eye goggles provided. -As soon as the session time has elapsed the lamps will automatically be switched off. 15 60 55 5045 40 3530 25 20 1510 5 MIN0 -If you wish to treat the other side of your body as well, you can set the timer again. (It is not necessary for the solarium to cool down first.) Lying - Place the solarium beside a bed or couch. -As the stand is on wheels you can draw the solarium towards you while lying. Ensure that the lamps are positioned straight above you (fig. 8). -You can move the stand under the bed (fig. 16). -After use, you can push the solarium away from you to make getting up easier. Sitting -Place a (deck) chair and the solarium together (fig. 9). -Bring the solarium in optimum position by turning the upper casing. 16 Standing -Turn the upper casing to bring it into a vertical position. If necessary adjust the height. -Stand in front of the solarium (fig. 10) - at least 20 cm (8”) away. Storage The solarium takes up very little space when stored in a vertical position (fig. 17). 17 Cleaning • Always unplug the solarium and let it cool down before cleaning. • You can clean the outside of the solarium with a damp cloth. Make sure that no water runs into the appliance. • Do not use abrasives or scourers. • Never use liquids such as alcohol, methylated spirits, petrol or acetone to clean the protective plate as this may cause irreparable damage. In the course of time (in normal family use after some years) the efficiency of the tube lamps will gradually decrease. If this happens, you may increase the tanning session time or have the tube lamps replaced. • You can have the tube lamps and/or the starters replaced by authorized service personnel: they have the required skill and the original replacement parts and tools to do the job. They also have the facilities to dispose of the used tube lamps. • If you prefer to replace the lamps yourself, proceed as follows: -First remove the mains plug from the wall socket. 1918 -Loosen the screws and remove the two end caps (fig. 18). -Pull out the protective shield completely (fig. 19). After this, the lamps and starters are accessible. -Rotate the lamps slightly to the left or to the right. When unlocked remove them from the lamp holders . -Remove the starters by turning slightly to the left and withdrawing . (Half the amount of starters are at each end of the solarium.) -To place new lamps and starters proceed in reverse order and direction. -Slide the protective shield back into the profile. Do not forget to fix the end caps by means of the screws. f f The tube lamps of solariums contain substances which may pollute the environment. When discarding old tube lamps, please ensure that they are separated from the normal household refuse and that they are disposed of at an officially assigned place. For U.K. only: Fitting a different plug This appliance is fitted with a BS 1363 13 Amp. plug. Should you need to replace the plug, connect the wires as follows: Brown wire to the Live (L) terminal of the new plug. Blue wire to the Neutral (N) terminal of the new plug. Always fit the same value of fuse as that originally supplied with your appliance. Only use BS 1362 approved fuses. As a guide only: Appliances under 700 W can have a 3 Amp. fuse (red) and all others should have a 13 Amp. fuse (brown). When disposing of an old plug (particularly the moulded type which has been cut from the mains cord) always remove the fuse as the plug could be dangerous if ever inserted in a live socket. 8 Solarium does not operate as required? If the solarium should not operate as required, this may be due to a defect. In this case do not hesitate to apply to your dealer or to a Philips Service Centre. However, it is also possible that the appliance has not been installed according to the instructions or is used incorrectly. If this is the case, you will be able to solve the problem immediately. You may check the following section before contacting your dealer or Philips Service Centre. Problem Possible cause • Solarium does not switch on. -Mains plug is not in wall socket. -No mains power. (Please check with other appliance.) -Timer has not been set. • The power fuse switches the mains power -Check the fuse to which the solarium has been connected. off when switching on or while using the The proper type for your solarium is a 13 A (for U.K.) or a 10 or 16 A (for solarium. other countries) normal fuse or a slow reacting automatic fuse. • ...

Baixe o seu

Para fazer o download, introduza 2 dígitos :