..................................................................................................................................................6 REMOVE MOTOR SLIDE CAPS...........................................................................................................................................6 INSTALL MOTORS................................................................................................................................................................6 INSTALL MOTO

is not responsible for typographical errors. Packaging, warranties, products andspecifications are subject to change without notice. Graham-Field and Lumex are registered trademarks, and Patriot is a trademark, of GF Health Products, Inc. © 2011, GF Health Products, Inc. 2 INTRODUCTION, PATRIOT HOMECARE BED USER MANUAL This manual contains assembly and maintenance instructions for your Model US0208 / US0208PL Semi-Electric and US0458 / US0458PL Full-Electric / Low Patriot bed. Read the entire ma

US0208-INS-LAB-RevD11 • Patriot Homecare Bed 2 CONTENTS 1 SAFETY................................................................................................................................................................................................3 WARNING / CAUTION / NOTICE SUMMARY..............................................................................................................................3 2 INTRODUCTION, PATRIOT HOMECARE BED USER MANUAL................................

Save this manual for future reference. Note: The most current version of this manual can be found online at Federal Law (USA) restricts this device to sale by or on the order of a physician. This device should not be used unless the operator has been instructed by a qualified healthcare professional. JB0112-164-INS-LAB-RevB09 John Bunn Neb-u-Tyke RR Train Nebulizer Compressor 2 This product has been tested and successfully approved with the following standards: UL1431 EN 60601-1 CONTENTS INTRODU

Lifting the patient from a bed 1. With patient face-up in center of bed, roll patient onto their side away from attendant. 2. Place sling, folded lengthwise, halfway under patient with lower edge just beneath knees. 3. Roll patient onto their side toward attendant, pull sling to smooth it, and center patient on sling. 4. Pull the leg loops forward and under the thighs. 5. Cross the loops, one through the other. 6. Roll the patient lift under the bed, locating the spreader bar over the patient. B

Contact your Lumex dealer for a new cylinder. LF1040 ELECTRIC PATIENT LIFT SYMPTOM POSSIBLE CAUSE ACTION Control box is not responding and relay is notclicking Battery discharged Charge battery Battery charger defective Replace battery charger Battery defective Replace battery Hand control defective Replace hand control Actuator does not run, butrelay is clicking Actuator plug not properly seated Push actuator plug firmly into control box Actuator defective Replace actuator Control box defective

5 SAFETY PRECAUTIONS ..................................................................................................... 6 FEATURES ........................................................................................................................... 8 HANDLING PROCEDURES ................................................................................................. 9 ASSEMBLY INSTRUCTIONS ............................................................................................. 10 O

. If possible, lower the bed before lifting. Move the patient lift away from the bed. Ensure that the occupants arms and legs clear the patient lift, bed, or any other obstacles. Warning: Do not attempt to transfer a patient without prior approval of the patient’s healthcare professional and without having read the instructions and practiced using the patient lift. Warning: Use special care for those patients who cannot cooperate while being lifted. Warning: Ensure all bolts, hooks, and loops ar

In addition, some models may be used in emergency situations. In an emergency situation, be sure to contact a physician or EMS immediately. 4 WARNING: DO NOT reuse plastic crush gaskets (fire risk). Set-Up (Yoke Style) • Inspect the cylinder following the instructions of your gas supplier. Be sure to purge the cylinder valve seat of debris. • Inspect the regulator for oil or grease. If either is visible, DO NOT use the regulator. • Be sure the sealing washer is in place on the inlet of the r