Assessments - 1, GPA: 5
(
)
)
|
Facilidade de uso
Adjust the cable length compensation if the cable between the Driver and the wallplate/receiver is over 100 feet long. Set the compensation at 1 for cables 100-199 ft. long, and 2 for 200-299 ft. cables, etc. Do not permanently mount the wallplate/receivers until after system testing. Carefully connect the A and B cables to the Driver(s), power the source components, TVs and AV receivers, and plug in 9871 power supplies to test the system. Connect a TV to each wallplate/receiver location to refine cable length compensation settings. Use the MINIMUM compensation setting that still provides the best picture. Ideally, Drivers should be located near the main home theater system, but if they must be placed far away, compensate for losses of the long 716-210 Made in USA by Audio Authority Corp. Toll Free USA and Canada: 800-322-8346 A B Cat 5 cable A Cat 5 cable B Cable Length Compensation 9878 Rear View coaxial cable by increasing the cable compensation setting by one click for each 200 feet of coaxial cable length (see diagram below). For example, if the coaxial cable length from main system to Driver is 220 feet (1 click) and the Cat 5 cable length to a certain wallplate is 250 feet (2 clicks), the correct Cable Length Compensation for that wallplate is 1 + 2 = 3 clicks. Conditions vary, so it is best to verify settings using the video display that 18-volt power supply PN 571-014 Cable Length Compensation = 4 Cable Length Compensation = 3 RCA Cable Length = 220 ft. A 9871 Driver B 9878 Wallplate 9878 Wallplate AV Source Component Cat 5 Cable Length = 370 ft. Cat 5 Cable Length = 250 ft. will be installed in each location. A pass-through F-connector is provided in case antenna connection is desired. (A separate coaxial cable must be pulled; antenna signals are not carried on the Cat 5 cable). Connecting to an IR network The DuoDrive does not have an IR remote control system; it provides a discrete three-strand Cat 5 pathway for a third party system. Connect an IR remote control system input to the Driver IR output stereo 3.5mm jack (see example diagram below). Connect an IR receiver to each wallplate/receiver and position them appropriately in the rooms. Do not connect any equipment to the vacant white RCA jacks marked “IR”. 18-volt power supply PN 571-014 Note: IR remote control system and receivers are not included. Note: This configuration of two 9871 Drivers could support four wallplates. A 9871 Driver BA B Wallplate AV Equipment Cat 5, Cat 5e, or Cat 6 Cable AV Equipment IR Remote Control System IR Receiver 9878 Remote IR In Case of Difficulty If any problems arise that are not covered in this manual, call Audio Authority Technical Support at 800-322-8346, or outside the US and Canada, call 859-233-4599. 2048 Mercer Road, Lexington, Kentucky 40511-1071 Phone: 859-233-4599 • Fax: 859-233-4510 Customer Toll-Free USA & Canada: 800-322-8346 Website: 752-480 11/08 ...
Este manual também é adequado para os modelos :receptor e amplificador - 9878 (292.33 kb)
receptor e amplificador - 9871 (292.33 kb)