Assessments - 3, GPA: 5
(
)
)
|
Facilidade de uso
Connect bus jacks for all channels whether or not they will be used. Pull two cables to each wallplate location, preferably using a different colored cable jacket for A and B cables. Install an RJ-45 termination on each end of every Cat 5 cable, using EIA-568B pairing (pins 12, 3-6, 4-5, 7-8). If possible, use EZ RJ-45 connectors. Check each cable with a network cable tester – CONTINUITY TESTING IS NOT ADEQUATE – the pairs must match the EIA-568B color code. WHT / ORNORNWHT / GRNBLUWHT / BLUGRNWHT / BRNBRN CATEGORY 5,5e or 6 CABLE Note: EIA 568A or B standard may be used. (B is pictured here.) Make sure both ends are terminated with the same color code. Category 5 Connector Termination This diagram is oriented with the latch on the RJ45 connector facing down. RJ45 LATCH Cable Length Compensation = 3 Cable Length Compensation = 1 Cat 5 Cable Length = 320 ft. Cat 5 Cable Length = 180 ft. RCA Cable Length = Less than 199 ft. A 9871 Driver B 9878 WallplateAV Equipment 18-volt power supply PN 571-014 9878 Wallplate Installing 9878 Wallplates BE CERTAIN to connect the A cable to the A jack and the B cable to the B jack or damage to the wallplate/receiver may occur. Adjust the cable length compensation if the cable between the Driver and the wallplate/receiver is over 100 feet long. Set the compensation at 1 for cables 100-199 ft. long, and 2 for 200-299 ft. cables, etc. Do not permanently mount the wallplate/receivers until after system testing. Carefully connect the A and B cables to the Driver(s), power the source components, TVs and AV receivers, and plug in 9871 power supplies to test the system. Connect a TV to each wallplate/receiver location to refine cable length compensation settings. Use the MINIMUM compensation setting that still provides the best picture. Ideally, Drivers should be located near the main home theater system, but if they must be placed far away, compensate for losses of the long 716-210 Made in USA by Audio Authority Corp. Toll Free USA and Canada: 800-322-8346 A B Cat 5 cable A Cat 5 cable B Cable Length Compensation 9878 Rear View coaxial cable by increasing the cable compensation setting by one click for each 200 feet of coaxial cable length (see diagram below). For example, if the coaxial cable length from main system to Driver is 220 feet (1 click) and the Cat 5 cable length to a certain wallplate is 250 feet (2 clicks), the correct Cable Length Compensation for that wallplate is 1 + 2 = 3 clicks. Conditions vary, so it is best to verify settings using the video display that 18-volt power supply PN 571-014 Cable Length Compensation = 4 Cable Length Compensation = 3 RCA Cable Length = 220 ft. A 9871 Driver B 9878 Wallplate 9878 Wallplate AV Source Component Cat 5 Cable Length = 370 ft. Cat 5 Cable Length = 250 ft. will be installed in each location. A pass-through F-connector is provided in case antenna connection is desired. (A separate coaxial cable must be pulled; antenna signals are not carried ...
Este manual também é adequado para os modelos :receptor e amplificador - 9870 (292.33 kb)
receptor e amplificador - 9878 (292.33 kb)