Assessments - 2, GPA: 3.5 ( )

Fabricante : Husqvarna Arquivo Tamanho: 1.31 mb Arquivo Nome : Língua de Ensino:

2 3 4 Fit the safety guard (A) against the gearbox (I) position the lower clamp (G) in the housing under the shield and the upper clamp (F) over the shaft. Insert and tighten the screws (H). ENGLISH - 5 Safety guard extension (exclusively for use E6. Assembly/disassembly of grass cutter with nylon string head) blade The string cutting blade housed in the plas E5. Assembly/disassembly of line cutter head ews are tightened all the way (E) and are not loosened by the vibrations. If necessary, tighten them again). eference notches (C), and fasten with the ews (D), then apply the string cutter blade (L) and fasten it with the screw (E) (Make sure the ect assembly see the illustration on the cover and perform the following sequence of steps: Insert the extension (B) on the safety guard (A) at The extension (B) should be installed only for use with the nylon string head, with the aid of the string cutter blade (L), that regulates the length of the string and thus the cutting diameter. For cor otation speed of the engine and interferes with cutting efficiency, as well as increasing the risk of tic shield will cut the nylon string to optiinjury. mum length; a string that is too long reduces the 2 3 4 10 Apply the nylon string head as shown in the illustration: 1) Upper plate 2) Nylon string head. Tighten by turning counterclockwise. As you tighten, hold the nylon string head and plate still and insert the wrench or screwdriver supplied in the holes in the plate and gearbox; first turn the plate until the two holes match. Do not use the nylon string head guard extension (H) with metal blades. Assemble blade as illustrated: a) Flange guard - b) Upper cap with blade centering - c) Blade with text and directional arrow facing upwards - d) Lower washer - e) Fixed mower gauge - f) Blade locking screw (length mm 16). If you want to assemble the rotating mower gauge,proceed as illustrated: a) Flange guard - b) Upper cap with blade centering - c) Blade with text and directional arrow facing upwards - d) Lower washer - e) Spacer - f) Rotating mower gauge - g) Blade locking screw (length mm 34,5). Assembly of sawtooth blade and blade guard When using the sawtooth blade, remove the guard for the line cutter head and grass cut- ting blade and replace the flange guard (A) with the sawtooth blade guard (H). Saw tooth blades (24 - 80 tooth) have a central base diametre of 20mm and there- fore require the use of the appropriate size top flange to ensure a correct fit. The part number is detailed in the cutting attachment summary chart. For assembly see figures (E7, E8). 2 3 4 10 2 3 4 10 F. Starting and stopping the engine position with the other starter string ar until you encounter some r cord sharply and forcefully (to start the engine 1 5 6 7 8 9 10 11 12 14 CAUTION! Start the brush cutter in a flat place. During startup stand in a stable position. Make sure the blade or nylon string head do not touch the ground or any obstacles. when Do not pull the starter cord all the way and do not release it abruptly against the machine as this could damage it. Startup of cold engine F1. Stop switch (A) turned to "I" opposite the "STOP" mark. F2. Turn the fuel enrichment lever (B) to the closed position. F3. Press the air purge diaphragm repeatedly until fuel begins to fill the diaphragm (C). The diaphragm need not be completely filled. Push the decomp...

Baixe o seu

Para fazer o download, introduza 2 dígitos :