Assessments - 0, GPA: 0
(
)
)
|
por este dispositivo também tem outras instruções :
Facilidade de uso
4 Known Problems and Limitations
This section provides a list of problems and limitations known to HP when these release notes
were published. If workarounds are available, they are included.
4.1 HP 8 Internal Port SAS Controller and HP Multi-Port Internal SAS Controller
•
Updating the adapter firmware to version 1.23.33 or later might change the target ID of
disk devices.
This occurs on rx2660, rx3600, and rx6600 servers when an Integrated RAID volume is
configured on the controller and you perform one of the following actions:
— Update the adapter firmware offline using sasflash.efi.
— Boot to an HP-UX or Ignite-UX disk containing the sasd driver from one of the following
releases, which download firmware version 1.23.33 to the adapter during boot:
◦
B.11.23.0712
◦
B.11.31.0712
Changing the target ID might cause physical disks, including the OS boot disk, to become
inaccessible. If some of the disks from the IR volume are inaccessible, the volume can become
degraded or fail.
NOTE:
The target ID change does not occur on systems without a RAID-1 volume. It also
does not occur on Bl860c servers with the HP Multiport SAS Controller.
For detailed information on how to avoid or correct this problem, see Updating Internal SAS
Controller Firmware to Version 1.23.33 Or Later at:
http://docs.hp.com/en/netcom.html
•
Before replacing a failed disk, make note of its Device Special File (DSF) information.
If you shut down a server to replace a failed disk offline, the DSF of the failed disk will not
be visible in ioscan when the server restarts. The DSF is required by the replace_tgt
command to rebuild the array with the new disk.
Corrective Action: Before you shut down the server, run ioscan and make note of the DSF
information for the failed disk.
For more information on replacing disks, see the HP 8 Internal Port SAS Controller and HP
Multi-Port Internal SAS Controller Support Guide at:
http://docs.hp.com/en/netcom.html
4.2 AH303A PCIe SC44Ge SAS Host Bus Adapter
•
Virtual Partitions will not boot in multi-initiator configurations under vPars A.4.05.
Virtual Partitions (vPars) version A.4.05 using an HP StorageWorks MSA60 or MSA70
enclosure do not boot if AH303A cards assigned to multiple virtual partitions are connected
to the same JBOD. Under the vPars I/O resource assignment rules, a host bus adapter cannot
be shared among multiple virtual partitions.
Corrective Action: This issue is corrected in vPars A.04.06 (B.11.23.0809).
•
Virtual Partitions will not boot if hardware reconfiguration changes the hardware path
under vPars A.4.05.
Virtual Partitions (vPars) using an HP StorageWorks MSA50/MSA60/MSA70 enclosure will
not boot if hardware paths change due to hardware reconfiguration. For more information
on the impacts of hardware reconfiguration, see the Ignite-UX and SAS Devices whitepaper
at:
http://docs.hp.com/en/oshpux11i.html
4
... Este manual também é adequado para os modelos :
Equipamento de rede - HP-UX 11i v2 I/O Cards (253.7 kb)