Do not use the electrical cord to move the machine. WARNING: Maintenance and repairs performed by unauthorized personnel could result in damage or injury. Maintenance and repairs must be performed by authorized personnel only. Keep all fasteners tight. Keep adjustments according to specifications. WARNING: Electrical components of this machine can "short-out" if exposed to water or moisture. Keep the electrical components of the machine dry. Wipe the machine down after each use. For storage, kee

WARNING! Be prepared to control the machine as soon as the motor starts. Just a slight up or down movement of the Handle will make the machine move from side to side. Raise the Handle to go right. Lower the Handle to go left. CAUTION! Immediately start moving the machine back and forth. Keep the machine moving while the motor is running to avoid damage to the floor or carpet. 4 Hold one of the Operator Hand Grips (1) firmly, push the Safety Lock Button (2) and then compress the Switch Levers (3)

Part No. Description Qty. 1 85383A Screw, 10-32 x 3/4 8 2 50779A Handle, Front 1 3 50798A Lever, Switch 2 4 50820A Spring, Extension 2 5 50806A Button, Interlock 1 6 40109A Switch 2 7 50799A Interlock, Main 1 8 50821A Spring, Compression 1 9 50780A Handle, Rear 1 10 920722 Nut, 10-32 ESNA 8 13 10084A Cord, Interconnect 1 14 461404 Cam, Locking (Included in 51) 1 15 925592 Roll Pin, . (Included in 51) 1 16 441301 Bolt, Locking Cam (included in 51) 1 17 980349 Washer, Wear Cam 1 18 50791A Arm Link

DANGER: Using a machine with a damaged power cord could result in an electrocution. Do not use the machine if the power cord is damaged. Do not use the electrical cord to move the machine. WARNING: Maintenance and repairs performed by unauthorized personnel could result in damage or injury. Maintenance and repairs must be performed by authorized personnel only. Keep all fasteners tight. Keep adjustments according to specifications. WARNING: Electrical components of this machine can "short-out" i

To reduce the risk of injury, always unplug the power cord before servicing. INSTALLING THE BRUSH OR PAD HOLDER Align the lugs with the corresponding slots in the brush or pad holder and turn the brush or pad holder counterclockwise to lock it in place (figure 2). To remove brush/pad holder, give it a quick, hard turn clockwise. Figure 2 LugsSlotsLENGUETASRANURASTENONSFENTES CAUTION! Using the wrong brush or pad on this machine can damage the floor or overload the motor. Figure 1 Page -18 - Clar

En caso de mal funcionamiento o de averia, el hilo de tierra es un camino de menor resistencia que permite el paso decorriente ; por lo cual se reduce el riesgo de choqueelectrico. La maquina tiene un cable de alimentacioncon tres conductores y un enchufe con tres clavijas delas cuales una esta puesta a tierra. El enchufe solo puede ser conectado con una caja de enchufereglamentaria, puesta a tierra con todas las reglas delarte y conforme a los reglamentos locales. AVISO : Una conexion incorrect