e Position the snow thrower so the oil drain plug isthe lowest point on the engine_ Remove the oil drain plug and oil fill cap/dipstick, Drain the oil into a suitable container. The oil will drain more freely when warm. Replace the oit drain plug and tighten securely_ Refill the crankcase with SA.E_ 10W-30 motor oi! (or equivalent)., S,A.E. 5W-30 motor oil may be used to make starting easier in areas where the temperature is consistently 20° F. or lower, SPARK PLUG o Make su re the spark plug is

inches. 1 inch = 25.4 mm IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. Failure to do so could be hazardous, damage your snow thrower and void your warranty. 45 BRIGGS & STRATTON 4-CYCLE ENGINE MODEL NUMBER 20M314-1370=E2 KEY PART KEY PART NO. NO. DESCRIPTION NO. NO. DESCRIPTION 528 793006 Hose-Primer 957 795027 Cap-Fuel 529 791822 Grommet 972 694260 Tank-Fuel 552 694674 Bushing-Governor Crank 975 698783 Bowl-Float 562 793216 Bolt (Governor Control Lever) 976 793

Use SAE 5W30 engine oil only. FILL OIL This snow thrower was shipped with a container of 5W30 oil. This oil must be added to the engine before starting. For extreme cold operating conditions of 0° F or below, use a partial synthetic 0W30 motor oil for easier starting. NOTE: In areas where temperature is consistently at 2CP F or lower, you may use 0W30 motor oil for easier starting. • Remove the oil fill cap/dipstick. • Pour the oil and fill the crankcase to line (Full) on dipstick (19 ounce

® Cut allfourcomersof the cartonfromtop to bottom and lay laythe panelsflat,. e Removethe packingmaterialfrom the shifterplate and upperhandleassembly. e Rollthesnowlhmweroffthecartonby pullingonthe lower handle,, NOTE: Thedrive systemmay betightwhenyoufirstuse yoursnowthrower.It loosensup as youuse ito e To completeupper handle installationand install chutecrankassembly,see To InstallThe UpperHandle and CrankAssemblyparagraphon page8. NOTE: Ifthecableshave becomedisconnectedfromthe clutchlevers

• Safety • Assembly • Operation • Maintenance • Parts PRINTED IN U.S.A. FORM NO. 49788 (REV. 7/05) Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A. IMPORTANT - READ THIS FIRST!!! For Missing Parts or Assembly Questions Please Call 866-576-8388 Mon.-Fri. 7 am - 5 pm CST. FAX 217-728-2032 or e-mail info@agri-fab.com Missing parts will be sent UPS in 24 hours di rect ly to your home. ® TABLE OF CONTENTS ACCESSORIES...........................................................2 SAFETY RULES....

60179 U.S.A. PRINTED IN U.S.A. RULES FOR SAFE OPERATIONS Any power equipment can cause injury if operated improperly or if the user does not understand how to operate the equipment. LOOK FOR THIS SYMBOL TO POINT OUT IMPORTANT SAFETY PRECAUTIONS, IT MEANS --ATTENTION! BECOME ALERTJ YOUR SAFETY IS INVOLVED, Exercise caution at all times, when using power equipment. 1. Read the tractor and snow blade owners manuals and know how to operate your tractor before using tractor with snow blade attachment

This manual provides information regarding the setup, operation, and maintenance of this product. We have made every effort to ensure the accuracy of the information in this manual. The manufacturer reserves the right to change this product at any time without prior notice. Please keep this manual available to all users during the entire life of the snow thrower. Copyright 2005 Yardworks(R). Do not reprint without written authorization. TABLE OF CONTENTS GENERAL SAFETY PROCEDURES ...............

60684 U.SoA. SAFETY RULES CAUTION: ALWAYS DISCONNECT SPARK PLUG WIRE AND A PLACE WIRE WHERE IT CANNOT CONTACT SPARK PLUG TO & PREVENT ACCIDENTAL STARTING WHEN SETTING-UP, TRANSPORTING, ADJUSTING OR MAKING REPAIRS. IMPORTANT SAFETY STANDARDS REQUIRE OPERATOR PRESENCE CONTROLS TO MINIMIZE THE RISK OF INJURY. YOUR SNOW THROWER IS EQUIPPED WITH SUCH CONTROLS. DO NOT ATTEMPT TO DEFEAT THE FUNCTION OF THE OPERATOR PRESENCE CONTROL UNDER ANY CIRCUMSTANCES, FUEL .SAFETY BEFORE USE ® Read the owner's man

Operator’s Manual 28” SNOW THROWER Model No. 247.887900 • SAFETY • ASSEMBLY • OPERATION • MAINTENANCE • PARTS LIST • ESPANOL ® 7/6/2007 FORM NO. 769-02587A TABLE OF CONTENTS Warranty.Statement...................................Page.2 Repair.Protection.Agreement....................Page.3 Safe.Operation.Practices..........................Pages.4-5 Safety.Labels.............................................Page.7. Assembly...................................................Pages.8-11 Operation.......

• Stop engine and wait several minutes before checking oil level. Remove oil fill cap and dipstick. • Wipe dipstick clean, insert it into oil fill hole and tighten securely. • Remove dipstick and check. If oil is not up to the FULL mark on dipstick, add oil. Changing Oil Change engine oil after first two hours of operation and every 25 hours thereafter. In order to change the oil, you will have to first drain the spent engine oil from the engine and then refill with fresh oil. • Drain oil while