Assessments - 3, GPA: 4.3 ( )

Fabricante : AEG Arquivo Tamanho: 1.42 mb Arquivo Nome : 917420EN.pdf Língua de Ensino:

on the display. ENGLISH 19 TROUBLESHOOTING TROUBLESHOOTING Problem1) Possible cause Remedy The tumble dryer is not connected to mains supply. Connect in at mains socket. Check fuse in fuse box (domestic installation). The tumble dryer does not operate. The loading door is opened. The On/Off button was not pushed. The Start/Pause button was not pushed. Close the loading door. Push the On/Off button. Push the Start/Pause button. The appliance is in the standby mode. Push the On/Off button. Incorrect programme selection. Do the selection of the applicable programme. 2) The filter is clogged. Clean the filter. 3) Unsatisfactory drying results. The condenser is clogged. Too high volume of the load. The airflow grill is clogged. Clean the condenser. 3) Obey the maximum load volume. Clean the airflow grill in the bottom of the appliance. Dirt on the inner surface of the drum. Clean the inner surface of the drum. Too high water hardness. Set applicable water hardness4). The door does not close. The filter not locked in the position. The laundry is locked between the door and the seal. Put the filter in the correct position. Put the load correctly in the drum. Err (Error) You try to change the programme or the function after the start of the cycle. Turn the tumble dryer off and on. Make the new selection. The function you try to activate Turn the tumble dryer off and is not applicable with the selec on. Make the new selection. ted programme. Abnormally The time to end is calculated on elapsing The automatic procedure — this the basis of the volume and time on the is not the appliance malfunction. dampness of the laundry. display.) Programme Drain the water container3) , The water container is full. inactive. push the Start/Pause button. 20 Drying cycle too short. To small laundry volume. The laundry is too much dried. Do the selection of time programme. Do the selection of time programme or higher drying level (e.g. Extra Dry ) The filter is clogged. Clean the filter. Drying cycle too long 5) Too high volume of the load. The laundry not spun sufficiently. Obey the maximum load volume. Spin correctly the laundry. Very high room temperature this is not the appliance malfunction. If possible, lower the room temperature. 1) If there is an error message on the display (e.g. E51): Turn the tumble dryer off and on. Make a selection of the new programme. Push the Start/Pause button. Does not operate? contact the service centre and give the error code. 2) follow the programme description — see PROGRAMMES chapter 3) see CARE AND CLEANING chapter 4) see section WATER HARDNESS in HINTS AND TIPS chapter 5) Note: After maximum 5 hours the drying cycle ends automatically (see Drying cycle complete section). ENGLISH 21 TECHNICAL INFORMATION height x width x depth 850 x 600 x 600 mm (maximal 640 mm) drum volume 118 l maximum depth with the load door 1090 mm opened maximum width with the load door 950 mm opened adjustable height 850 mm (+ 15 mm - feet regulation) the appliance weight 41 kg maximum load volume 7 kg voltage 230-240 V frequency 50 Hz necessary fuse 13 A total power 2800 W energy efficiency class B energy consumption kWh/cycle 1) 3,92 kWh annual energy consumption2) 284,1 kWh type of use Domestic permitted ambient temperature + 5°C to + 35°C 1) 7 kg of cotton, centrifuged at 1000 rpm with reference to EN 61121 2) The sum of approximate energy consumption to dry: 150 kg of the cotton laundry with cupboard dry programme + 280 kg with iron dry programme + 150 kg of synthetic laundry with cupboard dry programme. This is approximate consumption for the 4 person household which correctly use the tumble dryer. 22 INSTALLATION APPLIANCE POSITIONING • The tumble dryer must be installed in a clean position, where dirt does not collect. • Air must flow freely around the appliance. Make sure that the front airflow slots in the bottom of the appliance are not blocked . • To keep vibration and noise at the minimum, when the tumble dryer operates, it must be put on a stable and flat surface. • When the appliance is put in its permanent position, check if is fully level with the aid of a spirit level. If it is not, adjust the feet until it is. • Do not remove the feet. Do not decrease the floor clearance through thick carpets, bar of wood or equivalent. This can increase the heat which can cause interference with the operation of the appliance. • The temperature of the hot air which occurs in the tumble dryer can increase to 60 °C. The appliance must not be installed on the floor which is not resistant to high temperatures. • When the tumble dryer operates, the room temperature must not be lower than +5 °C and higher than +35 °C. This can cause unwanted effect on the performance of the appliance. • If it is necessary to move the appliance, it must be moved vertically. • The appliance must not be installed behind a lockable door, a sliding door, a door with a hinge on the opposite side to that of the appliance in ...

Baixe o seu

Para fazer o download, introduza 2 dígitos :