Assessments - 4, GPA: 3.8
(
)
)
|
Facilidade de uso
Should it be necessary to provide a fixed connection, the hood must only be installed by an electrician authorised by the local electricity board. When installing, an omnipolar disconnector with a distance of at least 3 mm between contacts must be provided. This disconnector may be for example a switch, fuses (plug fuses must be removed from the fuse box, fault current switches and remote switches with a distance of over 3 mm between contacts. The manufacture declines all responsibility for malfunctions resulting from failure to comply with the above instructions. If the power socket is applied directly above the hood this gives two advantages: 1. the socket is not visible. 2. the appliance can be disconnected at need merely be removing the plug. Electrical connection 220-240 V – by means of fixed power cable with plug. (Fixed connection of the appliance must only be carried out by an authorised electrician.) Wall unit mounting - Fig. 6 • First decide which functioning version is better for you. If you decide to use the hood in exhausting version we suggest to position the upper section of the chimney so that the oulet slots are not visible once installation has ended, on the contrary if is decided to use the hood in recycling version BE SURE that the side with slots is up (see also A-BC sequence on on Fig. 6). • Insert the frame, that holds controls, grease filter and lamps, in the motor housing using proper rails and fix each other with two 3x9 screws (12- 3). • Sign the wall with a center line, this will aid mounting procedure (4), position the template so that the mid line printed on the template matches with the center line previously signed, the lower side of the template corresponds to the lower side of the hood once mounted (5). • Drill two holes O 8mm and fix the support bracket with two wall plugs and screws (6). • Hang the hood (7) adjust its position (8-9) and from the inside of the hood sign one point for definitive fixing (10), remove the hood and drill an hole O 8mm (11), fit a wall plugs, hang the hood again and fix it definitively with a screw (12). • Drill two holes O 8mm on the upper side close to the ceilling (13), fit two wall plugs and fix the chimney support with two screws (14). In case the hood is to be used in Recycling version, mount the deflector F on the chimney support with four screws 2,9x6,5 and fit an exhausting pipe (15) to connect deflector to the outlet hole B of the hood. In case the hood is to be used in exhausting version, then the deflector must not be mounted and fit an exhausting pipe (15) to connect outlet hole B of the hood to the outside. • Make electrical connection (16), but leave the hood disconnected from the home general electric panel. • Connect lamps and control panel to the motor housing (17). • Insert the vapour catcher on the motor housing and fix it with four screws M4x35 (18). Model 3010D has an additional part that can be mounted to the first part fixed on step 18 before or after this step...
Este manual também é adequado para os modelos :Hobs - 3010 D (403.82 kb)
Hobs - 3000 D (403.82 kb)
Hobs - 3000 D (403.82 kb)
Hobs - 3010 D (403.82 kb)