Assessments - 3, GPA: 4 ( )

Fabricante : Air King Arquivo Tamanho: 2.99 mb Arquivo Nome : 31408b6d-7f29-4e8d-a231-1ff1a450f722.pdf Língua de Ensino:

• Clean the inner housing using a hand hot solution only(never use caustic detergents, abrasive powders or brushes). Fig. 3 Charcoal filter • The charcoal filter should only be used if you want to use the hood in recirculation mode. • Cleaning/replacing the carbon filter Unlike other carbon filters, the LONGLIFE carbon filter can be cleaned and reactivated. At normal use the filter should be cleaned every second month (when using the hood 2,5 hours per day, in avarage). The best way to clean the filter is in the dishwasher. Use normal detergent and choose the highest temperature (65. C). Wash the filter separately so that no food parts gets stuck on the filter and later causes bad odours. To reactivate the carbon, the filter should be dried in an oven for 10 minutes with a temperature of maximum 100. C. After approximately three years of use, the carbon filter should be replaced with a new one, as the odour reduction capacity will be reduced. • Fitting Remove the grease filters. Remove the frame i which supports the filter h by turning 90° the two knobs g. Insert the charcoal filter inside the frame and put all parts back in their place. Refit the grease filters. Fig. 4. • To remove proceed in the reverse order. • Always specify the hood model code number and serial number when ordering replacement filters. This information is shown on the rating plate located on the inside of the unit. • The charcoal filter can be ordered from your local Service Force Centre. Fig. 4 Fig. 5 Fig. 5 Warning • Failure to observe the instructions on cleaning the unit and changing the filters will cause a fire hazard. You are therefore strongly recommended to follow these instructions. • The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations. Changing the light bulbs • Disconnect the cooker hood from the mains supply. • Prior to touching the light bulbs ensure they are cooled down. • Extract the lamp cover by using a small flat screwdriver or similar tool as a lever. • Replace the old bulb with a new one of the same type. • Refit the lamp cover. • If the light does not come on, make sure the bulb has been inserted in correctly before contacting your local Service Force Centre. Cleaning the hood • Clean the outside of the hood using a damp cloth and a solution of water and mild washing up liquid. • Never use corrosive, abrasive or flammable cleaning products or products containing bleach. • Never insert pointed objects in the motor’s protective grid. • Only ever clean the switch panel and filter grill using a damp cloth and mild washing up liquid. • Clean all the plastic parts with a soft cloth soaked in warm water and neutral soap. • It is extremely important to clean the unit and change the filters at the recommended intervals. Failure to do so will cause grease deposits to build up that could constitute a fire hazard. Special accessories ...

Baixe o seu

Para fazer o download, introduza 2 dígitos :