Assessments - 3, GPA: 3.7
(
)
)
|
Facilidade de uso
11). 7. Check that the hood is at the right height. Minor height adjustments may be made with the screws U embodied in the brackets (see Fig. 11). 8. Tighten the two wall fixing screws R, through the two access holes N provided on the inside of the hood (Fig. 12) then fix the lower sliding frame to the hood with two screws O and washers previously unscrewed (item 4). Using the hood It is advisable to switch on the cooker hood a few minutes before starting cooking and then to leave it running fot approximately 15 minutes afterwards to ensure that all odours are extracted. On the front of the appliance there are control switches (see page 3). The switch marked with motor symbol controls fan power. The switch marked with lamp symbol controls the lighting of the cooking surface. The hood is also fitted with an automatic micro switch located on the right hand side behind the visor, the micro switch will switch the hood OFF, whatever selection is made with the slider switches when the visor is closed. When the visor is pulled open the hood will switch ON at its previous setting. — If the hood is run at the same time as an ambient-air dependent burner or fireplace (for example gas, diesel, coal or wood heaters, water heaters, etc.) be careful, because the hood, when it extracts air, removes the ambient air the burners of fireplace need for combustion. For safe operation and to prevent discharged gas from coming back into the room, make sure there is an air inlet, which may be provided through air-recycling doors, windows or wall boxes or by other technical devices. — No food must be cooked flambé underneath the hood. The use of an unprotected flame is dangerous for the filters and could cause a fire. Therefore never use an open flame under the hood. When frying foods, never leave the pan unattended, the cooking oil could ignite. If contaminated oil is used, spontaneaous ignition may occur even more readily. — The hood must not be connected to fuel exhaust flues (boilers, heating systems, water heaters, etc.). — The manufacturers do not accept liability for damage to the hood or its catching fire because of failure to observe the above instructions. Where flexible ducting is fitted the length should be no more than: — 3 metres with one 90° bend — 2 metres with two 90° bends. Bends of more than 90° will reduce the efficiency of the hood and reduce the air flow. 15 Maintenance Grease filter Removing the grease filter Carbon filter Removing the carbon filter Cleaning Before carrying out any maintenance disconnect the hood from the electricity supply. The grease filter traps the suspended grease particles, and is used in the hood regardless of whether the hood is in the extraction or recirculating mode. The thin synthetic filter (thickness about 1 mm) is installed inside the filter grille. It is changed when the top colouring appears on the bottom, i.e. you can see the colour through the filter grille. To remove the filter: a) Re...
Este manual também é adequado para os modelos :Fans - 302D (936.52 kb)
Fans - 302D (936.52 kb)
Fans - 302D (936.52 kb)
Fans - 302D (936.52 kb)