Assessments - 3, GPA: 4.3
(
)
)
|
Facilidade de uso
3). Fit the filter in the seat at the front and fasten it at the back with the two hooks E (fig. 4). The cover F (fig. 5) must be fitted over the hole B (fig. 1) fixing it with the special screw provided. This cover deflects the air forwards avoiding soilage of the rear wall. Important: In the extraction mode the exhaust air must not be introduced into a smoke flue or exhaust gas chimney.lntroduction of the exhaust air into a shaft used for ventilation of the installation spaces of firerooms is not permitted. If the exhaust air is introduced into a operational smoke flue or exhaust gas chimney, it is advisable to seek the advice of a competent chimney-sweep. The official exhaust air guidance regulations are to be complied with. During operation in the extraction mode, an adequate air opening of approximately the same size as the exhaust air opening should be ensured. According to the Provincial Building Regulations, the joint operation of fume extractor hoods and chimney-linked fireplaces, such as coal or oil-fired ovens and gas heaters, in the same space is subject to specific restrictions. In such spaces, the Fireplace Regulations only allow an underpressure of max. 0.04 mbar. The safe joint operation of chimney-linked appliances and fume extractor hoods is only guaranteed if space and/or dwelling (space/air interaction) are externally vented by a suitable supply air opening of around 500-600cm2 and an underpressure thereby avoided when the cooker hood is running. In doubtful cases, please seek the advice and consent of a competent chimney-sweep or the local building authorities. In spaces without a fireplace, the rule is: “Supply an air opening w as large as the exhaust air opening”, the efficiency of the hood in the extraction mode may be impaired by a greater opening. Operation of the hood in the recirculation mode in such circumstances is safe and is not subject to the regulations above. When installed, the minimum distance from the hob to the lower edge of the cooker hood must be 65cm for electric hobs or 75cm in the case of gas or mixed fuel hobs Recirculation mode Notes prior to installation Electrical connections Voltage and current Important # Please ensure that the voltage and current indicated on the rating plate agree with the voltage of your electricity supply. If your appliance has been equipped with a mains lead with a moulded-on type plug, you must comply with the following regulations: The plug moulded on to the lead incorporates a fuse. For replacement, use a 5 amp BS1362 fuse. Only ASTA approved or certified fuses should be used. If the fuse cover/carrier is lost, a replacement cover/carried must be obtained from an electrical goods retailer. If the socket outlets in your home are not suitable for the plug fitted to the appliance, then the plug must be cut off and destroyed for safety reasons, and an appropriate plug fitted. When wiring the plug ensure that all strands of wire are securely retained in each ...
Este manual também é adequado para os modelos :Fans - 302D (936.52 kb)
Fans - 302D (936.52 kb)
Fans - 302D (936.52 kb)
Fans - 302D (936.52 kb)