Assessments - 3, GPA: 4.3 ( )

Fabricante : Broan Arquivo Tamanho: 360.97 kb Arquivo Nome : d1b5bb98-f6bc-7604-61ff-ce9acc9dc8a9.pdf Língua de Ensino:

Extraction Mode Recirculation Mode 5 MAINTENANCE AND CLEANING Before carrying out any maintenance or cleaning isolate the cooker hood from the mains supply. The cooker hood must be kept clean, as a build up of grease or fat can be a fire hazard. External Cleaning Wipe the cooker hood frequently with warm soapy water using a mild detergent. Always wear protective gloves when cleaning the hood. Never use scouring pads or abrasive cleaners. Never use excessive amounts of water when cleaning particularly around the control panel. Synthetic Grease Filter The synthetic grease filter cannot be cleaned. It should be replaced approximately every three months or more often if the hood is used for more than three hours per day. It cannot be washed. To replace the synthetic paper grease filter 1. Open the visor. 2. Press inwardly on the two slide catches and lower the grille to the stop position. Raise the front edge of the grille through a 45° angle until it detaches itself from the guides. 3. Carefully ease out the metal wire retaining clips. 4. Clean the metal grille and clips before replacing the grease filter. Charcoal Filter The charcoal filter/s absorb the odours from cooking. They will slowly become saturated and gradually less effective. The charcoal filter cannot be cleaned, it should be replaced approximately every three months or more often if the hood is used for more than three hours per day. To Remove/Replace the Charcoal Filter/s 1. Remove the metal inlet grille. 2. Carefully turn the disk (C) anti-clockwise and remove the charcoal filter/s (B) from the motor support/s (A) as illustrated opposite. 6 3. Clean the metal inlet grille/s and motor support/ s before replacing the charcoal filter/s. 4. Place the new charcoal filter/s (B) over the motor support/s (A), and while holding the filter securely insert the disk (C) and turn clockwise. This appliance can be a fire hazard if the grease and charcoal filters are not replaced as recommended. Changing the Lamps If a lamp fails to function check that the lamp is securely screwed into the holder. To tighten the lamps turn clockwise, but ensure not to over tighten them and break the lens. When changing the lamps an identical replacement must be fitted to ensure the safe working of the cooker hood. The replacement lamps are specified 220-240 volt 40 watt clear cylindrical shape lens with a small (E14) screw thread. Replacement charcoal filters, grease filters and lamps can be obtained from your local Service Force Centre. 7 SOMETHING NOT WORKING If, having followed these instructions carefully, your cooker hood fails to work properly please carry out the following checks. Symptom Solution The cooker hood will not start • Check the hood is connected to the electricity supply. • Check that the fan speed control is set to 1, 2 or 3. The cooker hood is not working effectively • The fan speed is set high enough for the task. • The grease filter is clean. • The kitchen is adequately vented to allow the entry of fresh air. • If set up for recirculation, check that the charcoal filter is still effective. • If set up for extraction, check that the ducting and outlets are not blocked. The cooker hood has switched off during operation • The safety cut-out device has been tripped. • Turn off the hob and then wait for the device to reset. If after all these checks, the problem persists, contact your local Service Force Centre, quoting the model and serial number. Please note that it will be necessary to provide proof of purchase for any in-guarantee service calls. In-guarantee customers should ensure that the above checks have been made as the engineer will make a charge if the fault is not a mechanical or electrical breakdown. SE...

Baixe o seu

Para fazer o download, introduza 2 dígitos :