|
Facilidade de uso
They will slowly become saturated and gradually less effective. The charcoal filter cannot be cleaned, it should be replaced approximately every three months or more often if the hood is used for more than three hours per day. To Remove/Replace the Charcoal Filter/s 1. Remove the metal inlet grille. 2. Carefully turn the disk (C) anti-clockwise and remove the charcoal filter/s (B) from the motor support/s (A) as illustrated opposite. 6 3. Clean the metal inlet grille/s and motor support/ s before replacing the charcoal filter/s. 4. Place the new charcoal filter/s (B) over the motor support/s (A), and while holding the filter securely insert the disk (C) and turn clockwise. This appliance can be a fire hazard if the grease and charcoal filters are not replaced as recommended. Changing the Lamps If a lamp fails to function check that the lamp is securely screwed into the holder. To tighten the lamps turn clockwise, but ensure not to over tighten them and break the lens. When changing the lamps an identical replacement must be fitted to ensure the safe working of the cooker hood. The replacement lamps are specified 220-240 volt 40 watt clear cylindrical shape lens with a small (E14) screw thread. Replacement charcoal filters, grease filters and lamps can be obtained from your local Service Force Centre. 7 SOMETHING NOT WORKING If, having followed these instructions carefully, your cooker hood fails to work properly please carry out the following checks. Symptom Solution The cooker hood will not start • Check the hood is connected to the electricity supply. • Check that the fan speed control is set to 1, 2 or 3. The cooker hood is not working effectively • The fan speed is set high enough for the task. • The grease filter is clean. • The kitchen is adequately vented to allow the entry of fresh air. • If set up for recirculation, check that the charcoal filter is still effective. • If set up for extraction, check that the ducting and outlets are not blocked. The cooker hood has switched off during operation • The safety cut-out device has been tripped. • Turn off the hob and then wait for the device to reset. If after all these checks, the problem persists, contact your local Service Force Centre, quoting the model and serial number. Please note that it will be necessary to provide proof of purchase for any in-guarantee service calls. In-guarantee customers should ensure that the above checks have been made as the engineer will make a charge if the fault is not a mechanical or electrical breakdown. SERVICE AND SPARE PARTS If you require an engineer or wish to purchase spare parts contact your local Service Force Centre by telephoning: 08705 929929 Your telephone call will be routed to your local Service Force Centre. For further details please see the the back of this book. For general assistance with your appliance or for information on Moffat products please contact our Customer Care Department. Customer Care Department, Moffat 55 - 77 High Street Slough Berkshire SL1 1DZ Tel: 08705 950 950* * calls to this number may be recorded for training purposes. 8 GUARANTEE CONDITIONS STANDARD GUARANTEE CONDITIONS We, Moffat, undertake that if within twelve months of the date of the purchase this Moffat built-in appliance or any part there of is proved to be defective by reason only of faulty workmanship or materials, the company will, at our option repair or replace the same FREE OF ANY CHARGE for labour, materials or carriage on condition that: • The appliance has been correctly installed and used only on the electrical supply stated on the rating plate. • The appliance has been used for normal domestic purposes only, and in accordance with the manufacturer’s operating and m...
Este manual também é adequado para os modelos :Fans - MCH 662 (360.97 kb)
Fans - MCH 662 (360.97 kb)
Fans - MCH 662 (360.97 kb)
Fans - MCH 662 (360.97 kb)