Assessments - 0, GPA: 0
(
)
)
|
por este dispositivo também tem outras instruções :
Facilidade de uso
5. Pull out the two knobs on the bracket
shown at right. Then remove that brack-
et.
Jumper Connector
Board Connector
6. Set the jumper connector, located at the
top left of the board to be installed, to the
position shown at right.
Initial State
Installed State
2
8
2
8
1
7
1
7
Board Connector
7. Insert the board and confirm that the
position is correct. Then push it in
straight.
8. After installing the boards, secure them
by tightening the screws and knobs
shown above.
Note: Refer to the WJ-FS616 Operating
Instructions for further details. VD2
and data settings are required on
the SET UP MENU of the Video
Multiplexer.
N0797-0
YWV8QA4699AN
Printed in Japan
N 19
...