A. Stainless tubular handle B. 2 Handle standoffs C. 3 Screws for mounting handle standoffs F. (2 required, 1 extra) D. 3 Set screws (2 required, 1 extra) E. 3/32" Allen wrench for set screws F. 4 U-Clips H. G. 4 Leveling legs H. GE Monogram nameplate A. I. 8 Plug buttons J. Hinge Shims I. K. 2 Screws for light trigger hole E. G. CAUTION: Small objects are a choke hazard to children. Remove and discard any parts not used. PRUDENCE – Les petits objets peuvent etrangler les enfants. Il faut jeter

The Monogram beverage center and wine chiller can be used freestanding or as a built-in. Dimensions & Clearances Front ventilation allows the beverage center or wine chillder to be installed as a built-in and still operate efficiently. The bottom front grille area must remain unobstructed for proper air circulation and operation. Cutout dimensions shown allow for a full door swing and access to the pull-out racks. Locate Outlet 34-1/2"-35" 24" Min. 24" Min. 5" 34-1/2" 24-1/8" 23-7/8" Installatio

If this is not done, the adapter ground terminal is very likely to break with repeated use. Should the adapter ground terminal break, DO NOT USE the appliance until a proper ground has again been established. Use of Extension Cords Because of potential safety hazards under certain conditions, we strongly recommend against the use of an extension cord. However, if you still elect to use an extension cord, it is absolutely necessary that it be a UL listed 3-wire grounding type appliance extension

IMPORTANT: Save these instructions for local inspector’s use. IMPORTANT: OBSERVE ALL GOVERNING CODES AND ORDINANCES. NOTE TO INSTALLER: Be sure to leave these instructions with the Consumer. NOTE TO CONSUMER: Keep these instructions with your Owner’s Manual for future reference. This appliance must be properly grounded. See “Electrical Supply”, page 4. WARNING If you received a damaged beverage center or wine chiller, you should contact your dealer. ATTENTION Cet appareil doit etre correctement