Assessments - 2, GPA: 4 ( )

Fabricante : Beverage-Air Arquivo Tamanho: 337.81 kb Arquivo Nome : 621457EN.pdf Língua de Ensino:

There are some sounds during normal use (compressor, refrigerant circulation). Problem Possible cause Solution The appliance does not operate. The lamp does not operate. The appliance is switched off. Switch on the appliance. The mains plug is not connected to the mains socket correctly. Connect the mains plug to the mains socket correctly. The appliance has no power. There is no voltage in the mains socket. Connect a different electrical ap- pliance to the mains socket. Contact a qualified electrician. The lamp does not work. The lamp is in stand-by. Close and open the door. 12 12 What to do if… Problem Possible cause Solution The lamp is defective. Refer to "Replacing the lamp". The compressor operates The temperature is not set cor- Set a higher temperature. continually. rectly. Water flows on the rear plate of the refrigerator. Water flows into the re- The water outlet is clogged. Clean the water outlet. frigerator. Products prevent that water Make sure that products do not flows into the water collector. touch the rear plate. Water flows on the There is too much water in the Clean the air deflector. ground. air deflector. The temperature in the The temperature regulator is not Set a higher temperature. appliance is too low. set correctly. The temperature in the The temperature regulator is not Set a lower temperature. appliance is too high. set correctly. The temperature in the refrigerator is too high. The door is not closed correctly. The door has been opened too frequently. The product temperature is too high. The room temperature is too high. During the automatic defrosting process, frost defrosts on the rear plate. The door is not closed correctly. The product temperature is too high. Many products are stored at the same time. There is no cold air circulation in the appliance. Refer to "Closing the door". Do not keep the door open longer than necessary. Let the product temperature decrease to room temperature before storage. Decrease the room temperature. This is correct. Refer to "Closing the door". Let the product temperature decrease to room temperature before storage. Store less products at the same time. Make sure that there is cold air circulation in the appliance. The temperature in the Products are too near to each Store products so that there is freezer is too high. other. cold air circulation. There is too much frost. Food is not wrapped correctly. Wrap the food correctly. The door is not closed correctly. Refer to "Closing the door". The temperature regulator is not Set a higher temperature. set correctly. Replacing the lamp 1. Disconnect the mains plug from the mains socket. Technical data 13 2. Remove the screw from the lamp cover. 3. Remove the lamp cover (refer to the illustration). 4. Replace the used lamp with a new lamp of the same power and specifically designed for household appliances. (the maximum power is shown on the lamp cover). 5. Install the lamp cover. 6. Tighten the screw to the lamp cover. 7. Connect the mains plug to the mains socket. 8. Open the door. Make sure that the lamp comes on. Closing the door 1. Clean the door gaskets. 2. If necessary, adjust the door. Refer to "Installation". 3. If necessary, replace the defective door gaskets. Contact the Service Center. TECHNICAL DATA Dimension Width 596 mm Depth 550 mm Rising Time 13 h Voltage 230-240 V Frequency 50 Hz Height 815 mm The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label. INSTALLATION WARNING! Read the "Safety Information" carefully for your safety and correct operation of the appliance before installing the appliance. Positioning This appliance can be installed in a dry, well ventilated indoor (garage or cellar) also, but for optimum performance install this appliance at a location where the ambient temperature corresponds to the climate class indicated on the rating plate of the appliance: 14 14 Installation Climate class Ambient temperature SN +10°C to + 32°C N +16°C to + 32°C ST +16°C to + 38°C T +16°C to + 43°C Electrical Connection CAUTION! Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. WARNING! This appliance must be earthed. The manufacturer declines any liability should these safety measures not be observed. The wires in the mains lead are coloured in accordance with the following code: 1 Green and Yellow: Earth 35 Brown: Live Blue: Neutral As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: 1. Connect the wire coloured green and yellow to the terminal marked either with the letter “E“ or by the earth symbol or coloured green and yellow. 2. Connect the wire coloured blue to the terminal either marked with the letter “N“ or coloured black. Environmental concerns 15 3. Connect the wire coloured brown to the terminal either marked with ...

Baixe o seu

Para fazer o download, introduza 2 dígitos :