Assessments - 2, GPA: 4.5 ( )

Fabricante : Samsung Arquivo Tamanho: 10.49 mb Arquivo Nome : Língua de Ensino:

Do not pull the lever out. You could damage or break the lever's spring. • To clean the ice bin/bucket, wash with a mild detergent, rinse well, and dry thoroughly it. Do not use harsh or abrasive cleaners or solvents. • When you select Cubed Ice after using the Crushed Ice mode, a small amount of residual crushed ice might be produced. • In case ice doesn’t come out, pull out the ice bucket and press the test button located on the right side of ice maker. • Do not press the test button continuously when the tray is fi lled with ice or water. Water may overfl ow or ice may jam the bucket. • Normal Use To fi ll the ice bucket to maximum capacity after installation, follow these steps: 1. Allow your refrigerator to operate and cool down for 24 hours (or 1 full day). - Waiting 24 hours will allow your ice maker to cool properly. 2. Dispense 4 to 6 ice cubes into the glass. 3. After 8, and then 16 hours, dispense a full glass of ice. Recommend Temp (Fridge) : 38F NO ICE Select this if you want to turn ice maker off 1 2 check the water level Test button CAUTION CAUTION DA68-01922A.indb 16 2012.5.16 2:59:33 PM • When you press the Test button, you will hear the refrigerator chime (ding-dong). When the chime sounds, release the Test button. • The chime sounds automatically again to let you know the ice maker is working well. If a power failure occurs, ice cubes may melt then freeze together when the power comes CAUTION back on, causing the dispenser to be out of order. To prevent this problem, after a power failure, pull out the ice bucket and discard the CAUTION residual ice or water. After you dump the ice from the ice bucket, you should press the dispenser lever once with the ‘ICE CUBED’ or ‘CRUSHED’ function ON. The ice maker will make new ice faster after you return the ice bucket in the refrigerator. If you use all the ice at once, you must repeat Steps 2 and 3 on the previous page. However, only wait 8 hours before dispensing the first 4 to 6 ice cubes. This will replenish the ice cubes and ensure maximum ice production. USING THE ICE OFF FUNCTION When you select the Ice Off mode, remove all ice cubes from the bucket. If you are not using the ice dispenser, the ice cubes may clump together. Pull the lock lever forward to remove the bucket. Throw away the ice cubes or clumped ice. Push the bucket back until you hear a click. PULL PUSH Use only the ice maker provided with the refrigerator. The water supply to this CAUTION refrigerator must only be installed/connected by a suitably qualified person. Connect to a potable water supply only. To operate the ice maker properly, water pressure of 138 ~ 862Kpa is required. If you have a long vacation or business trip and won’t use the water or ice dispensers for a long time: - Close the water valve. Otherwise, water leakage may occur. - Remove all food. - Unplug the refrigerator. - Wipe excess moisture from inside and leave the doors open. Otherwise, odor and mold may develop. Do not put your fingers, hands or any other unsuitable objects in the chute or ice-maker bucket. - It may result in personal injury or material damage. Never put your finger or any other objects in the dispenser opening. - It may cause injury. Do not try to disassemble the ice maker. Do not wash or spray the ice bucket with water while it is in the refrigerator. Remove it to clean it. Water clouding phenomenon All water provided to the refrigerator flows through the core filter which is an alkaline water filter. In the filtering process, the pressure of the water that has flowed out of the filter is increased, and the water becomes saturated with oxygen and nitrogen When this water flows out into the air, the pressure plummets and the oxygen and nitrogen get supersaturated, which results in gas bubbles. The water may temporarily look misty or cloudy due to these oxygen bubbles. After a few seconds, the water will look clear. Please wait 1 second before removing the cup after dispensing water to prevent spills. Do not pull out the lever dispenser after dispensing ice or water. It comes back automatically. Ice is made in cubes. When you select “Crushed”, the ice maker grinds the ice cubes into crushed ice. operating _17 02 OPERATING M DA68-01922A.indb 17 2012.5.16 2:59:34 PM 18_ operating PARTS AND FEATURES Use this page to become more familiar with the parts and features of the refrigerator. When closing the door, make sure the Vertical Hinged Section is in the correct position to avoid scratching the other door. If the Vertical Hinged Section is reversed, put it back to the right position and close the door. Moisture may appear at times on the Vertical Hinged Section. The door handle may become loose over time. If this happens, tighten the bolts found on the inside of the door. If you close one door with a lot of force, the other door may open. When the door opens, the interlock switch automatically turns off the auger motor in the ice maker for safety reasons. When the interior or exterior LED ...

Baixe o seu

Para fazer o download, introduza 2 dígitos :