Assessments - 5, GPA: 4.2
(
)
)
|
Facilidade de uso
Use PHASE to select the phase polarity. Depressing PHASE reverses the polarity and may provide better bass reproduction in certain listening environments (depending on the type of front speakers, the position of the woofer and the adjustment of the cut-off frequency). It may also change the expanse and tightness of sound, and effect the feeling of sound field. Select the setting that provides the sound you prefer when listening in your normal listening position. 5 5 Repeat steps 2 to 4 to adjust for your preference. Once you have adjusted the woofer to the settings you desire, use the VOLUME control on the amplifier to adjust the volume of the woofer with that of the other speakers. You don’t need to adjust the woofer settings when you change the volume level of the amplifier. 1/08-09_SAW10.EN 3-810-424-12 (1) 9EN Basic Operations Additional Information Additional Information Precautions On safety • Before operating the woofer, be sure that the operating voltage of your woofer is identical with that of your local power supply. • Unplug the woofer from the wall outlet if it is not to be used for an extended period of time. To disconnect the cord, pull the cord by grasping the plug. Never pull the cord itself. • Should any liquid or solid object fall into the woofer, unplug the woofer and have the woofer checked by qualified personnel before operating it any further. • AC power cord must be changed only at the qualified service shop. When turning on or off an amplifier or other equipment Lower the volume of the amplifier to minimum. To avoid damaging the woofer • Be careful in setting the volume control of the amplifier to avoid an excessive input power. • Do not attempt to open the enclosuer or remold speaker units and networks. • The grill net is not removable. Do not remove it. In case color irregularity is observed on the nearby TV screen With the magnetically shielded type of the speaker system, the speakers can be installed near a TV set. However, color irregularity may still be observed on the TV screen depending on the type of your TV set. If color irregularity is observed... nTurn off the TV set once, then turn it on after 15 to 30 minutes. If color irregularity is observed again... nPlace the speakers further apart from the TV set. When howling occurs Relocate the speaker or turn down the volume of the amplifier. On installation • Do not install the woofer near heat sources such as radiators or air ducts, or in a place subject to direct sunlight, excessive dust, mechanical vibration or shock. • Good ventilation is essential to prevent internal heat build-up in the woofer. Place the woofer in a location with adequate air circulation. Do not place the woofer on a soft surface or too close to a wall as this may obstruct the ventilation hole on the back. On cleaning the cabinet Clean the cabinet with a soft cloth lightly moistened with water. Do not use any type of abrasive pad, scouring powder or solvent such as alcohol or benzine. If you have any questions or problems concerning your woofer that is not covered in this manual, please consult your nearest Sony dealer. 10EN Troubleshooting If you experience any of the following difficulties while using the woofer, use this troubleshooting guide to help you remedy the problem. Should any problem persist, consult your nearest Sony dealer. There’s no sound. /Check that this woofer and components are connected correctly and securely. /Rotate LEVEL clockwise to turn the volume up. The sound has suddenly stopped. /The speaker cords may have short-circuited. Connect the cords properly. The sound is distorted. /The input signal is imperfect. /The input signal level is too high. Severe hum or noise is heard. /Connect the ground wire of the turntable properly. /The contacts between the plugs of the connecting cords and the corresponding jacks have not been made properly. Connect the plugs firmly. /The audio system is picking up some noise from a TV set. Move the audio system away from the TV set or turn the TV set off. 1/10-11_SAW10.11EN 3-810-424-12(1) Additional Information Additional Information Specifications For the U.S.A. model Audio power specifications POWER OUTPUT AND TOTAL HARMONIC DISTORTION: With 8 ohm loads, from 20 – 20,000 Hz; rated 23 watts per channel minimum RMS power, with no more than 0.8 % total harmonic distortion from 250 milliwatts to rated output. System Type Active Super Woofer (magnetically shielded design) Speaker unit Woofer: 16 cm (6 5/16 inches), cone type Practical maximum output U.S.A. and Canada 23 W Europe and Malaysia 28 W (8 ohms, DIN) 50 W (MUSIC) Other countries 35 W Reproduction frequency range 28 Hz – 200 Hz High frequency cut-off frequency 50 Hz – 200 Hz Phase switch NORMAL, REVERSE Inputs Input jacks INPUT 1: Input pin jack INPUT 2: Input terminals General Power requirements Where purchased Models Power requirements U.S.A. and Canada All models 120 V AC, 60 Hz Europe All models 220 - 230 V AC, 50/60 Hz Malaysia SA-W10 220...
Este manual também é adequado para os modelos :Speakers - SA-W10G (156.15 kb)
Speakers - SA-W10H (156.15 kb)