Log:
Downloads : 0   Arquivo Tamanho: 4 kb   Fabricante : KitchenAid  
Categoria : Portas e janelas

Downloads : 0   Arquivo Tamanho: 4 kb   Fabricante : KitchenAid  
Categoria : Portas e janelas

Downloads : 3   Arquivo Tamanho: 4 kb   Fabricante : KitchenAid  
Categoria : Portas e janelas

Downloads : 0   Arquivo Tamanho: 4 kb   Fabricante : KitchenAid  
Categoria : Portas e janelas

Downloads : 8   Arquivo Tamanho: 12 kb   Fabricante : Gianni Industries  
Categoria : Portas e janelas

Downloads : 4   Arquivo Tamanho: 14 kb   Fabricante : Gianni Industries  
Categoria : Portas e janelas

Downloads : 0   Arquivo Tamanho: 18 kb   Fabricante : Ives  
Categoria : Portas e janelas

Downloads : 0   Arquivo Tamanho: 19 kb   Fabricante : Ives  
Categoria : Portas e janelas
@name

Determine pivot location using dimensions on reverse side. Depth of mortise in the bottom of door will determine clearance. Be sure to properly locate and mark pivot center point of the base plate. Locate, drill, and tap 1/4-20 mounting holes for metal door. Locate and drill pilot holes for #14 wood screws for wood door. Mount door leaf in bottom of door with 1 /4-20 x 3/4” FHMS or #14 FHWS screws provided. Locate, drill, and tap mounting holes for jamb base plate. Pivot point of top pivot set

Downloads : 7   Arquivo Tamanho: 19 kb   Fabricante : Gianni Industries  
Categoria : Portas e janelas
@name

This module is designed to interface with any Remote Security System with Ground Pulsed door lock outputs. When interfacing to AUDIOVOX SECURITY Products, verify that the 2-wire door lock output connector from the alarm module is loaded with a Red and a Green wire. NOTE: If the 2-pin door lock output connector from the Alarm Module is loaded with a Red and Black wire, you must use the model AA-9158 Door Lock Interface. 2. This module will require the addition of the optional "PDA-1" Kit in these

Downloads : 8   Arquivo Tamanho: 19 kb   Fabricante : Audiovox  
Categoria : Portas e janelas
@name

Serrures a inversion de polarite a 4 ou 5 fils: l'un des fils est sous tension positive de 12V en permanence, un ou deux autres fils sont mis a la masse en permanence. Tous les autres fils sont sous tension positive de 12V lorsque la commande est dans l'une des deux positions (blocage ou deblocage) et la polarite s'inverse avec mise a la masse lorsque la commande change de position. (Dans certaines voitures, la tension positive de 12V accompagne la position "blocage" et la mise a la masse la pos





categorias