Assessments - 3, GPA: 3.7
(
)
)
|
por este dispositivo também tem outras instruções :
Facilidade de uso
( p. 14) 2 Open the slide cover to turn the camera on. ( p. 15) Make sure that the sufficient Battery Power indicator ( ) appears on the LCD panel. ( p. 15) 3Load the film. ( p. 16) Pull the film leader across to the red index mark inside the film compartment. For wide-angle For telephoto 4 Press the Zoom lever and compose your picture. ( p. 21) 8 Getting Started 5 Press the shutter release button halfway. ( p. 20) When you press the button halfway, focus and exposure are automatically achieved, and the green LED lights up. 6 Check the green LED is on, then press the shutter release button all the way to release the shutter. ( p. 20) En The film starts to rewind automatically, when film reaches the end of the roll. ( p. 23) Remove the film cartridge. ( p. 23) Take trial shots Take trial shots before shooting at important occasions like weddings or graduations. • Nikon will not be held liable for any damages resulting from the use of this product. Getting Started 9 Camera parts Body Viewfinder window Autofocus window Slide cover (power switch) ( p. 15) Strap eyelet( p. 11) Shutter release button ( p. 19) button Red-eye Reduction ( pp. 32, 33) Self-timer ( p. 34) Remote control* ( p. 35) LCD panel( p. 12) Lens Zoom lever ( p. 21)button Flash mode ( pp. 26-31) Infinity Focus mode ( p. 37) Remote-control sensor* ( p. 35) Flash ( pp. 26, 27) Red-eye Reduction lamp( pp. 32, 33) Self-timer lamp ( p. 34) Auto Exposure metering window Autofocus window Mid-roll rewind button ( p. 23) * Lite Touch Zoom 110s QD only 10 Getting Started MODE button* (for selecting date to be imprinted or corrected) ( pp. 18, 38) Date panel* ( pp. 18, 38) position of date to corrected) ( p. 38) ( pp. 13, 20) Orange LED(for correcting date) ( Batterychamber lid ( ADJUST button* Green LED Viewfinder p. 13) SEL button* (for selecting theFilm confirmation window Tripod socketCamera back lock En pp. 13, 27) ( p. 38) eyepiece( p. 14) release lever ( ( pp. 29, 31, 34, 35) p. 16) Getting Started Attaching the strap Put your head through this loop. Attach the strap as shown in the illustration. Adjust the length using thelug on the strap. 11 Camera parts (continued) LCD panel Red-eye Reduction indicator ( pp. 32, 33) Battery power indicator Infinity Focus ( p. 15) Flash Mode indicator Mode indicator ( pp. 26-31) ( p. 37) Self-timer indicator Frame counter ( p. 17) ( p. 34) Remote Control indicator ( p. 35) (Lite Touch Zoom 110s QD only) The illustrations are fully labeled for your reference. 12 Getting Started Viewfinder 1 2 3 4 En 1Parallax compensation marks ( p. 22) Use for close-up shooting distance less than 1m in telephoto setting. 2Autofocus frame marks ( p. 20) Center the main subject to be in focus with in this frame. 3Orange LED ( p. 27) Slowly blinks while the flash is being charged, and lights up when the flash is ready to fire. If you press down on the popped-up flash unit, the LED blinks rapidly as a warning. 4Green LED ( p. 20) Lights when focus is achieved. In close-up photography, if the subject is closer than approx. 0.8m, the green LED blinks as a warning when you press the Shutter Release button halfway, and the shutter cannot be released. Note that you may take a picture even if the camera-to-subject distance is extremely short (approx. 0.1m) and out of the control range of the camera. However, the focus may not be sharp. Getting Started 13 Installing a battery 2Install a new battery. Insert the battery with the and ends positioned as marked inside the battery chamber. 3Close the battery chamber lid until it clicks. 1Open the battery chamber lid. While releasing the lock as indicated by the arrow in the left illustration, open the battery chamber lid. Battery type Use one CR123A or DL123A type 3V lithium battery in this camera. MADEINCHINA MADEINCHINA MADEINCHINA MADEINCHINA When the battery for the camera is replaced, the date/time may be reset. Be sure to check the day/time after replacing the battery and correct if necessary. ( p. 38) 14 Preparations Turning the camera on Open the slide cover until it clicks. Once you open the slide cover in the direction of the arrow, the camera is turned on, the built-in flash automatically pops up, and the lens extends out. The camera is set in Auto flash mode. ( p. 30) En When closing the cover, first slide it slightly in to start lens retraction. When the lens is completely retracted, slowly close the cover. Checking the battery power Make sure that the sufficient Battery Power indicator ( ) is showing on the LCD panel. showing The battery power is sufficient. blinking The battery is nearing exhaustion. Have a fresh one ready. no indicators Replace the battery with a new one. Always check the battery condition before shooting. We recommend that you take spare batteries with you, especially when travelling. Preparations 15 Loading the film Recommended film Use DX-coded 35mm film with this camera. It is recommended to use DX-coded ISO 400 film, which provides good results when using the ...