: Cut at a steady pace to avoid having to make several passes. 1 = Gunning sight for cutting blade. : Fit square nut (4) in the loop handle, insert the clamp screw (5) from the other side and tighten down securely. Adjusting loop handle to most comfortable position: : Release clamp screw (5) . : Move the loop handle along the drive tube as required - retighten the clamp screw. 14 FC 83 english / USA Fitting the Cutting Blade : Place the power edger on a suitable support so that the blade mountin

An AV system is recommended for those persons using power tools on a regular or sustained basis. : Wear gloves and keep your hands warm. : Keep the AV system well maintained. An edger with loose components or with damaged or worn AV buffers will tend to have higher vibration levels. : Maintain a firm grip at all times, but do not squeeze the handles with constant, excessive pressures, take frequent breaks. All the above mentioned precautions do not guarantee that you will not sustain whitefinger

If spilled and ignited by a spark or other ignition source, it can cause fire and serious burn injury or property damage. Use extreme caution when handling gasoline or fuel mix. Do not smoke or bring any fire or flame near the fuel or the power tool. Note that combustible fuel vapor may escape from the fuel system. Fueling Instructions Warning! Fuel your power tool in well-ventilated areas, outdoors. Always shut off the engine and allow it to cool before refueling. Gasoline vapor pressure may bu

Advertencia! Lea y siga todas las precauciones de seguridad dadas en el manual de instrucciones – el uso incorrecto puede causar lesiones graves o mortales. Instruction Manual 1 - 34 Manual de instrucciones 35 - 73 English Contents © ANDREAS STIHL AG & Co. KG, 2009Printed on chlorine-free paperOriginal Instruction Manual0458- 545- 8621-A. M1. D9.PM. Printing inks contain vegetable oils, paper can be recycled. 0000001053_002_GB Guide to Using this Manual Safety Precautions and Working Techniques

With the engine running only at idle, attach the power tool to the spring hook of your harness (see appropriate chapter of this manual). Working Conditions Operate and start your power tool only outdoors in a ventilated area. Operate the edger under good visibility and daylight conditions only. Work carefully. ! Warning! Your edger produces toxic exhaust fumes as soon as the engine is running. These gases ( e.g. carbon monoxide) may be colorless and odorless. To reduce the risk of serious or fat