Log:
Downloads : 1   Arquivo Tamanho: 162 kb   Fabricante : Empire Comfort Systems  
Categoria : Eléctrico
@name

The installation must conform with local codes, or in the absence of local codes, with the National Fuel Gas Code ANSI Z223.1. *Available from the American National Standards Institute, Inc., 11 West 42nd St., New York, N.Y. 10036. DO consult your dealer and local gas supplier about qualified installers and servicemen. DO refer to your Empire Installer and Serviceman's Manual so that you can make sure that all installation and service work was done properly. You bought the best furnace, now make

Downloads : 1   Arquivo Tamanho: 162 kb   Fabricante : Empire Comfort Systems  
Categoria : Eléctrico
@name

— WHATTO DO IFYOU SMELL GAS • Do not try to light any appliance. • Do not touch any electrical switch; do not use any phone in your building. • Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions. • If you cannot reach your gas supplier, call the fire department. — Installation and service must be performed by a qualified installer, service agency or the gas supplier. WARNING: If not installed, operated and maintained in accordance with the manufact

Downloads : 1   Arquivo Tamanho: 162 kb   Fabricante : Empire Comfort Systems  
Categoria : Eléctrico
@name

Now the pilot lights the gas and your furnace is on. When the living area is warm enough, the wall thermostat switches off, the main gas valve closes and your furnace turns off. The pilot remains lit waiting to light the gas the next time the thermostat calls for heat and turns the furnace on. TEMPERATURE CONTROLS Your Empire furnace has two safety switches (limits). When either switch turns off, it turns your furnace off, even if the wall thermostat is calling for heat. One of these switches ca

Downloads : 11   Arquivo Tamanho: 674 kb   Fabricante : Empire Comfort Systems  
Categoria : Eléctrico
@name

Cleaning Pilot Orifice After use, cleaning of the pilot burner may be required for the proper flame. Also, cleaning of the pilot burner may be required due to spiders (spider webs). The pilot orifice can be cleaned with high pressure air or by placing under running water. Pilot orifice must be dry before replacement. Use a pipe cleaner to clean inside the pilot after the pilot orifice has been removed. Cleaning Combustion Chamber When the main burner and vent cap are removed, all internal areas

Downloads : 2   Arquivo Tamanho: 675 kb   Fabricante : Empire Comfort Systems  
Categoria : Eléctrico
@name

This appliance is only for use with the type of gas indicated on the rating plate. This appliance is not convertible for use with other gases, unless a certified kit is used. Installer: Leave this manual with the appli- ance. Consumer: Retain this manual for future refer- ence. — Do not store or use gasoline or other flamma- ble vapors and liquids in the vicinity of this or any other appliance. — WHAT TO DO IF YOU SMELL GAS • Do not try to light any appliance. • Do not touch any electrical switc

Downloads : 6   Arquivo Tamanho: 685 kb   Fabricante : Empire Comfort Systems  
Categoria : Eléctrico
@name

The depth is 3", which enables the vent cap to be extended away from siding or projections. The wall depth plus the additional 3" depth of the vinyl siding vent cap extension should not exceed a total depth of 13" for DV-55. (See Figure10) Figure 9 Figure 10 12431-9-0408 Page 11 LIGHTING INSTRUCTIONS FOR YOUR SAFETY READ BEFORE LIGHTING WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life. A. This applia

Downloads : 2   Arquivo Tamanho: 699 kb   Fabricante : Empire Comfort Systems  
Categoria : Eléctrico

Downloads : 0   Arquivo Tamanho: 700 kb   Fabricante : Empire Comfort Systems  
Categoria : Eléctrico
@name

This is a heating appliance and any panel, door or guard removed for servicing an appliance must be replaced prior to operating the appliance. State of Massachusetts: The installation must be made by a licensed plumber or gas fitter in the Commonwealth of Massachusetts. General Information ThisfurnaceisdesigncertifiedinaccordancewithAmericanNational Standard/CSA Standard Z21.86 and CSA 2.32 by the Canadian Standards Association, as a Gravity Direct Vent Wall Furnace to be installed on an outside

Downloads : 1   Arquivo Tamanho: 705 kb   Fabricante : Empire Comfort Systems  
Categoria : Eléctrico
@name

If the gas control is turned to the “OFF” position or gas flow to the appliance is shut off, the pilot cannot be relighted until the safety magnet is deenergized (approximately 60 seconds). There will be an audible “click” when the safety magnet in the gas control is de-energized. Pilot can now be relighted. Repeat steps 5 through 9. 11. Turn gas control knob counterclockwise to “ON”. 12. Turn on all electric power to the appliance. (If applicable) 13. Replace access panel (front panel). Set the

Downloads : 0   Arquivo Tamanho: 705 kb   Fabricante : Empire Comfort Systems  
Categoria : Eléctrico
@name

1. The chimney must be lined and sized properly. Most masonry chimneys are over sized and absorb too much heat to be considered a proper vent. If you have any doubts line the chimney with the right size liner. If it's unlined you must line it. 2. Use an insulated liner when the chimney is on the outside, three sides exposed to the weather, and there is no clay liner in the chimney. The insulation will help keep the flue gases warmer. Insulated Vent Enclosure Vented room heaters installed with th





categorias