Vendor does not authorize any person or company to assume for it any other obligation or liability in connection with the sale, installation, use, removal, return, or replacement of its equipment, and no such representations are binding on Vendor. Blue Rhino Global Sourcing, Inc Winston-Salem, North Carolina USA (800) 762-1142 Cleaning and Care (continued) Troubleshooting If the problem is: And this condition exists: Then do this Pilot won’t light Note: Heater operates at reduced efficiency belo

• Never connect two or more extension cords together. • Use the shortest extension cord possible. • Keep connections dry and off the ground. • Avoid draping the electric heater cord where children or animals could encounter it. Before Turning “ON” 1. Make sure all labels, packaging and protective films have been removed from the heater. 2. Heater should be thoroughly inspected before each use, and by a qualified service person at least annually. Turning “ON” Illustration 1 1. Plug the power cord

It is essential to keep the heater’s valve compartment, burners, and circulating air passages clean. Inspect heater before each use. Installation and repair should be done by a qualified service person. Do not alter heater in any manner. Do not use the heater unless it is COMPLETELY assembled and all parts are securely fastened and tightened. This heater should be thoroughly inspected before each use. Clean and inspect the hose before each use of the appliance. If there is evidence of abrasion,

WARNING: Be careful when attempting to manually ignite this heater. Holding in the control know for more than 10 seconds before igniting the gas will cause a ball of flame upon ignition. Have a question or are having problems visit or call 1.800.762.1142. Note: the burner may be noisy when initially turned on. To eliminate excessive noise from the burner, turn the control knob to the pilot position. Then, turn the knob to the level of heat desired. When heater is ON: Emitter screen will become b

If no bubbles appear after one minute turn LP gas tank valve to “CLOSED”, wipe away solution and proceed. Before Lighting 1. Heater should be thoroughly inspected before each use, and by a qualified service person at least annually. 2. If relighting a hot heater, always wait at least 5 minutes. 3. Inspect the hose assembly for evidence of excessive abrasion, cuts or wear. Suspected areas should be leak tested. If the hose leaks, it must be replaced prior to operation. Only use the replacemen

Vendor does not authorize any person or company to assume for it any other obligation or liability in connection with the sale, installation, use, removal, return, or replacement of its equipment, and no such representations are binding on Vendor. Blue Rhino Global Sourcing, LLC Winston-Salem, North Carolina 27105 USA (800) 762-1142 Cleaning and Care (continued) Troubleshooting If the problem is: And this condition exists: Then do this Pilot won’t light Note: Heater operates at reduced efficienc

input Heat Range: Up to 20 foot diameter Fuel: Liquid Propane Gas (LP) Tank Size: Nominal 20 lb / 5 Gallon Inlet gas supply pressure: Maximum - 150 PSI Minimum - 5 PSI Manifold Pressure: 11.00 in. W.C. Engine: IPP E8 Safety Features: 100% Burner shut-off Tilt Switch Manufacturer: Blue Rhino Global Sourcing, LLC Made In: China 21 Owner's manual: model GWU511A outdoor patio heater Si necesita ayuda llame al 1.800.762.1142 No devuelva el artículo al lugar de compra. fk ADVERTE

15 Operation Checklist................................................... 16 Troubleshooting .......................................................... 17 Maintenance............................................................. 18 Storage................................................................. 19 Service................................................................. 19 Warranty................................................................ 20 Specifications....................

Do NOT attempt to assemble without proper tools. (1) Leak Detection Solution (Instructions on how to make solution are included in “Checking for Leaks” section) (1) Precision Filled LP Gas Grill Tank with Acme Type 1 external threaded valve connection (4-5 gallon size) Note: You must follow all steps to properly assemble heater. Typical assembly: approximately 1 (one) hour. Step 1: Unpacking heater Note: When unpacking your heater from the carton, you will find that the engine assembly and

input Heat Range: Up to 10 foot diameter Fuel: Liquid Propane Gas (LP) Tank Size: 14.1 oz. (400 grams) 16.4 oz. (465 grams) Inlet gas supply pressure: Maximum - 150 PSI Minimum - 5 PSI Manifold Pressure: 11.00 in. W.C. Supply Pressure: 0.41 psig (11.00 in. W.C.) Engine: IPP E8 Safety Features: Oxygen Depletion Sensor (ODS) shutdown system 100% Burner shut-off Tilt Switch Manufacturer: Blue Rhino Global Sourcing, Inc Made In: China Contact 1.800.762.1142 for assistance. Do n