Mesh screen on burner glows red when lit. After burner is lit, continue holding in safety shut-off valve plunger (about 10 - to 30 seconds) until heater stays lit. 5. If the burner does not light within 30 seconds, turn regulator knob to the “OFF” position. Wait at least two minutes for the gas to dissipate before relighting. 6. If heater will not light after repeated tries, do not attempt to repair heater. Return heater to nearest authorized service center or to the address on back of this ma

1 Table of Contents Specifications........................................................................................................................................2 General Safety Instructions...................................................................................................................3 Safety Precautions................................................................................................................................3 Heater Assembly................

Read the installation, operating and maintenance instructions thoroughly before installing or servicing this equipment. Operating Information This is a propane, direct-fired, heater. Its intended use is primarily temporary heating of buildings under construction, alteration or repair. A WARNING: Not for home or recreational vehicle use. Propane is heavier than air. If propane leaks from a connection or fitting, it sinks to the floor, collecting there with the surrounding air, forming a poten

Do not use inside house, camper, tent, vehicle or any type of unvented or enclosed area. 5. Never operate heater while sleeping or unattended. Keep children and animals away from heater. 6. This heater produces carbon monoxide, which is listed by the State of California as a reproductive toxin under Proposition 65. 7. Minimum heater clearances from combustibles: Top and Front 5 ft. Sides and Rear 3 ft. 8. Use only in well vented areas. 9. Use only propane gas set up for vapor withdrawal.

• Remove ashes from the ash pan and replace with a moisture absorbing material (such as kitty litter) to keep the interior of the stove dry. • Inspect and clean the refractory package and catalyst. • Clean the dust from the inner sides of bottom, rear or pipe heat shields if your stove is equipped with them. Clean surfaces are better heat reflectors than dirty surfaces. • Touch up the black paint. 24 7001135 Dutchwest The Chimney Connector When to Suspect A Combustor Problem TWO WEEKS: • Inspect

[G] 20” (510 mm) [H] 18” (460 mm) N/A [I] 18” (460 mm) [J] 12” (300 mm) N/A Top exit1 , rear h.s. Single-wall connector No connector h.s. [K] 20” (510 mm) [L] 23” (580 mm) [M] 18” (460 mm) [N] 18” (460 mm) [O] 18” (460 mm) [P] 17” (430 mm) Top exit1,2 , rear h.s. Single-wall connec- tor with connector h.s. [K] 20” (510 mm) [L] 18” (460 mm) [M] 17” (430 mm) [N] 18” (460 mm) [O] 12” (300 mm) [P] 15” (380 mm) Top exit1 , rear h.s. Double-wall connector [K] 20” (510 mm) [L] 14” (360 mm) [M] 16” (410

For safety, follow all installation, operation and maintenance directions. Contact local building officials about restrictions and installation inspection requirements in your area. DO NOT DISCARD THIS MANUAL: Retain for future use 7001135 12/07 Rev. 20 Dutchwest The Dutchwest models covered in this Owner’s Guide have been tested and listed by Inchcape Testing Services / Warnock Hersey of Middleton, Wisconsin. The test standards utilized were ANSI/UL 1482 for the United States and CAN/CGA - B366