FOR YOUR SAFETY Do not store or use gasoline or other flammable vapours and liquids in the vicinity of this or any other appliance. WHAT TO DO IF YOU SMELL GAS: • Do not try to light any appliance. • Do not touch any electrical switch. • Do not use any phone in your building. Installation and service must be performed by a qualified installer, service agency or the gas supplier. • Immediately call your gas supplier from a neighbour's phone. Follow the gas supplier's instructions. • If you cannot

• FOR OUTDOOR USE ONLY. • THIS APPLIANCE MUST NOT BE USED FOR COOKING. • THIS UNIT IS NOT FOR USE WITH SOLID FUEL • Improper installation, adjustment, alteration, service, or maintenance can cause injury or property damage. Read the installation, operating and maintenance instructions thoroughly before installing or servicing this equipment. • This appliance shall be used ONLY outdoors in a well- ventilated space and shall NOT be used inside a building, garage, or any other enclosed area. • Cyli

vents through the wall or roof • 4" & 7" rear venting • Overall depth of 12" makes for endless installation possibilities with a minimum of space • No hearth extension required saving you space in smaller rooms • Ground level and above installations • Basement installations even below grade using a Periscope (#GD201) • Approved for installation in bathrooms, bedrooms and bed-sitting rooms • Suitable for mobile home installations • Hot air distribution kit optional • Approved with Simpson Dura-Ve

W415-0297 / D / 04.03.03 FINISHING LOGO PLACEMENTHOOD HOOD CURTAIN MESH FIGURE 11 FINISHING LOGO PLACEMENTHOOD HOOD CURTAIN MESH FIGURE 11 The curtain mesh must be kept fully closed during operation to help prevent accidental burns from occurring. FIGURE 12 The heater must not be used when the hood is removed. Hook the hood over the lip of the curtain support plate. Remove the backing of the logo supplied and place on the screen cover, as indicated. FIGURE 13 CATALYTIC DOOR OPENING & CLOSING DOO

Imagine the warm glow from the PHAZer® log set and the luxurious heat - Life is good! Accent your backyard area and immerse yourself in the enjoyment of outdoor living. The GSS42 features heat resistant glass doors and shimmering stainless steel trim. Designer Options Decorative sandstone brick panels remote ControlFeatures and Benefits • 100% stainless steel construction for maximum durability • No venting or chimney required, making installationa simple process• Up to 65,000 BTU’s of warm, lux

Keep burner and control compartment clean. When lit for the first time, the fireplace will emit a slight odour for a few hours. This is a normal temporary condition caused by the curing of the logs and the “burn-in” of internal paints and lubricants used in the manufacturing process and will not occur again. After extended periods of non-operation such as following a vacation or a warm weather season, the fireplace may emit a slight odour for a few hours. This is caused by dust particles burning

Follow the gas supplier's instructions. • If you cannot reach your gas supplier, call the fire department. WARNING: If the information in these instructions is not followed exactly, a fire or explosion may result causing property damage, personal injury or death. FOR YOUR SAFETY Do not store or use gasoline or other flammable vapours and liquids in the vicinity of this or any other appliance. WHAT TO DO IF YOU SMELL GAS: • Do not try to light any appliance. • Do not touch any electrical switch.

Tighten fittings using 2 wrenches. 6. When connecting regulator assembly to the tank valve, hand tighten black QCC1 nut clockwise to a positive stop. DO NOT use a wrench to tighten. Use of a wrench may damage the quick closing coupling nut and result in a hazardous condition. 7. Locate the hose out of pathways where people may trip over it or in areas where the hose may be subject to accidental damage. 8. Open tank valve fully (counter-clockwise). Turn the on/off valve at the unit slowly to the

Level using four of the levelling screws. See Figure 1a. Levelling the unit will eliminate rocking or excessive noise when the fan is in operation. Once the unit is level, move it partially into place within the fireplace to allow for all connections to be made. It is not practical to level the insert once it has been installed. Determine the required depth prior to installing the unit and adjust the four levelling screws accordingly. Chimney installation must conform to both national and local

..... • It is imperative that the control compartments, burners and circulating blower and its passageway in the stove • It is imperative that the control compartments, burners and circulating blower and its passageway in the stove• It is imperative that the control compartments, burners and circulating blower and its passageway in the stove• It is imperative that the control compartments, burners and circulating blower and its passageway in the stove• It is imperative that the control compartme