Set to a level appropriate for your needs SmartPilot® ST6002 Controller r Use -1 or +1 to adjust response level. Press disp to return to previous mode. To Adjust Lighting Level 1 sec LRMP him Use disp to adjust lighting level. Wait 10 sec to return to previous mode. WheelPilot \Quick Reference Guide/ Display Layout To activate the Autopilot standby Press for Manual Control auto Press to activate the Autopilot course change keys Port 1° Starboard 1° Port 10° Starboard 10° disp

Trackpad Used to control the on-screen cursor and to scroll through menu items. Press the corresponding edge of the trackpad to move the cursor horizontally, vertically or diagonally. Press and hold to move rapidly over larger distances. CANCEL Press to cancel the selected on-screen option when editing data; also used to return to the previous soft key set or menu. MENU Press to access the set up menus. ACTIVE When multiple windows are open: - Press to select required window. - Press and hold to

Press again to accept the new course mode Press to select Wind Vane mode res m Press to resume previous course Press to adjust calibration, response and gain course change keys Port 1° Starboard 1° Port 10° Starboard 10° auto Press to activate the Autopilot standby + auto Press for Wind Vane mode standby Press for Manual Control L To activate the Autopilot For Manual Control 115176 To change the Autopilot Heading To follow a Route set on a Chartplotter

Set to a level appropriate for your needs SmartPilot® ST7002 Controller r Use? or ▲ to adjust response level. Press disp to return to previous mode. To Adjust Lighting Level 1 sec Use disp to adjust lighting level. Wait 10 sec to return to previous mode. \j3uick Start GuideJ Display Layout disp Press to display data pages Press for 1 second for lamp control Press for 3 seconds for power off resp Press to display response level track When the Autopilot is activated, press to folow

Initiates the Dual-Watch monitor mode. Pressing FUNC + MON/TRI starts the Tri-Watch monitor mode. Changes the volume of the handset. Alternately inputs the characters 2, A, B, and C. Pressing FUNC + 2/SCAN toggles ON and OFF the Scan mode. TRI VOL SCAN POWER Switches to DSC Individual Ships Call mode for initiating ship-to-ship or ship-to-shore calls using a specific MMSI number. Switches to the All Ships Call mode for Safety and Urgency transmissions. MEM Alternately inputs a 1 or a space chara

In this case, proceed to 'Cutting the bracket'. • There are two alternative slots for the bracket in the back cover of the wheel drive (Slot 1 and Slot 2). • Locate the motor tube where: • a 55 mm (21/e in) hole can be cut in the bulkhead/pedestal (if required) • the seal and ring can be secured around the motor tube • there is sufficient space behind the mounting location to allow at least 10 mm (0.4 in) clearance around the motor (see diagram below) CAUTION: Mount the drive so the motor