Assessments - 2, GPA: 3.5
(
)
)
|
Facilidade de uso
(4) If oil adheres to the element (sponge), squeeze it firmly. (5) For heavy contamination: 1) Remove the element (sponge), immerse it in warm water or in water-diluted neutral detergent, and dry it completely. 2) Clean the element (felt) with gasoline, and dry it completely. (6) Before attaching the element, be sure to dry it completely. Insufficient drying of the element may lead to difficult startup. (7) Wipe out with waste cloth, oil adhering around the air cleaner cover and plate breather. (8) Immediately after cleaning is finished, attach the air cleaner cover and tighten it with fixing bolts. (In remounting, first place the upper claw, and then the lower claw.) Air cleaner cover Element (felt) Element (sponge) Fixing bolt Breather Part Plate Pick this part and remove the element (felt). DANGER • • Clean the element several times a day, if excessive dust adheres to it. If operation continues with the element remaining not cleared of oil, oil in the air cleaner may fall outside, resulting in oil contamination. 3. Checking the spark plug (1) Opening/closing the plug cover When opening the cover, apply fingers to the main handle and plug cover projection as shown in the figure right. Push up the projection and slide the cover in the “OPEN” direction. When closing the cover, slide the cover in the “CLOSE” direction till the click under the plug cover projection rides over the engine cover. Finally, push in the projection. (2) Removing the spark plug Use an attached box wrench to remove or install the spark plug. (3) Checking the spark plug The clearance between two electrodes of spark plug (see the figure left) is 0.7 to 0.8 mm. Adjust to the correct clearance when it is too wide or too narrow. Clean thoroughly or replace the spark plug if it has accumulated carbon or contaminated. (4) Replacing the spark plug For replacement, use NGK-CMR6A. (3) (1) (2) Lateral electrode (-) Electrode clearance 0.7 -0.8 mm (0.028-0.031 in) 15 4. Cleaning the fuel filter • Clogged fuel filter may cause difficulty of startup or failure of engine speed increase. • Check the fuel filter regularly as follows: (1) Remove the fuel tank cap, drain the fuel to empty the tank. Check the tank inside for any foreign materials. If any, wipe clean such materials. (2) Pull out the fuel filter with wire through the oil filling port. (3) If the fuel filter surface is contaminated, clean it with gasoline. Foul gasoline must be disposed of according to the method specified by each local authority. Excessively foul filter must be replaced. (4) Reset the fuel filter in the fuel tank and tighten firmly the fuel tank cap. For replacement, contact your dealership or an authorized service agent. Fuel tank cap Fuel filter Hose clamp 5. Inspection of bolts, nuts and screws • Retighten loose bolts, nuts, etc. • Check for fuel and oil leakage. • Replace damaged parts with new ones for safety operation. 6. Cleaning of parts • Keep the engine always clean. • Keep the cylinder fins free of du...
Este manual também é adequado para os modelos :Clippers - PS-410 (3.24 mb)
Clippers - PB-250.4 (3.24 mb)
Clippers - PB-500 R (3.24 mb)
Clippers - PS-33 (3.24 mb)